Admiral Craft FZS-1D/B- Owner's Manual
Contents
1. Clean the condenser if necessary NO INTERIOR LIGHT Ensure that the bulb is properly installed in the socket Check to see if the bulb needs to be replaced Turn off the light switch then turn it on again UNIT IS NOISY Check for any loose parts or mounting Make sure the unit is on a flat sturdy surface Make sure all tubing is away from any contact that would cause a rattling sound Make sure there is minimum clearance of 6 from any walls THERE IS CONDENSATION ON CABINET AND OR FLOOR Make sure that the gasket on door or head is creating a proper seal Reduce the humidity in the area NOTES RETAIN THIS MANUAL FOR FUTURE REFERENCE Please read the entire manual carefully before installing and operating If certain recommended procedures are not followed warranty claims will be denied Notice Admiral Craft reserves the right to make changes in design and specifications without prior notice MODEL SERIAL COMPRESSOR SERIAL _ PURCHASE DATE2. COMMERCIAL REFRIGERATOR AND FREEZER OWNER S MANUAL Glass Door Merchandisers Models G368BMF D368BMF D768BM2F G1 2YBM2F This manual contains important information about your Admiral Craft unit Please read the manual thoroughly prior to equipment set up operation and maintenance Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty MUST READ INSTALLATION This refrigeration system will operate best when it is installed in an area that has cool dry air Do not put in direct sunlight Be sure that the unit is properly grounded All units are equipped with a three prong ground plug on the service cord for your safety Make sure that there is at least 6 inches of clearance on both sides and the back of the cabinet This refrigeration system should be located away from heat and moisture generating equipment such as ovens etc Unit should be installed on a surface that can support the weight of the entire unit including its contents Surface should also be flat This unit was designed for indoor use only Outdoor use will void any warranty PRECAUTIONS Use caution to not overload the outlet Do not use flammable products near the unit or spray the unit with water If you must unplug the unit you must wait at least 6 minutes before plugging it back in If you do not wait the 6 minutes the compressor may fail When cleaning Be sure to unplug the power co
3. rd with dry hands prior to cleaning Cracking or discoloration of plastic parts may occur if you use harsh abrasive solvents or polishing agents Avoid such products If you will not be using the unit for an extended period of time unplug the unit wipe the inside with a dry cloth Door may be left slightly open to eliminate moisture and odor OPERATION AND MAINTENANCE When loading the unit Do not block the air ducts located at the back and top of the unit with product as this will block the air flow thereby decreasing the unit s performance For best results keep at least 6 inches of clearance between the product and the air duct The temperature controller is located at the right front corner of the ceiling The default setting is 4 Do not leave the unit door open for extended periods of time when the unit is on and plugged in For best results close the door immediately after use TROUBLESHOOTING SYMPTOMS POSSIBLE SOLUTION COMPRESSORS WILL NOT START Ensure that the power cord is plugged in to appropriate outlet Check circuit for blown fuse INADEQUATE PERFORMANCE Make sure that the door is closed Move the unit away from anything that generates heat Check if there is a blockage in the air duct Make sure that the unit is in a well ventilated area with a minimum clearance of 6 from any walls Check to see if refrigerant is low Make sure that the temperature controller is set correctly
Download Pdf Manuals
Related Search