Gold Heater Operating Instructions
Contents
1. Gold Heater Operating Instructions Models HSIH 1000 and HSIH 800 Please Keep These Instructions For Future Reference IMPORTANT Ensure all instructions are read before use Mounting amp Positioning e Keep out of reach from children at all times e Ensure that your heater is disconnected and has been allowed to cool before cleaning or handling e Do not obstruct the heater or cover the heater in any way when the heater is in use e Ensure that the mains cable is not touching the outer casing of the heater e Ensure that this unit is only switched on once the installation process has been completed e Do not use an extension cable to power this unit as this could cause the unit to overheat and a risk of fire e Ensure that you do not touch the heater when in use always turn off the unit and allow to cool e Ensure that your electricity supply voltage corresponds with the stated voltage for this heater Remove the mounting brackets by unscrewing the 2 bolts and nuts my Ensure that the heater is mounted at a safe distance away from any flammable surface and that the unit is mounted on a non flammable surface Once a suitable location has been selected fix the bracket securely Position the heater to your desired angle using the bolts on either side of the bracket once positioned to a desired angle ensure e Always ensure that the unit is disconnected from the that the bolts are fully tightened mains p2. or cleaning is attempted 2 After approximately 100 hours it is recommended Note that the front cover of the unit is opened and the inside of the glass and reflector is cleaned with a lint free cloth Always make sure that the unit has been allowed to cool before this action is taken If the inside of the glass or the reflector shows a milky colouring this is normal due to internal vapours To clean this open the front cover and clean the glass and the reflector with a lint free cloth All measurements amp Dimensions of this product are approximate and due to the company s policy of research amp development can be subject to change without prior notice Always consult a qualified electrician
3. ower supply when fitting or replacing the halogen element Replacing the Halogen Element e Ensure that the halogen element has cooled down before replacement e Do not handle the halogen element with bare hands as moisture can shorten the life of the element Technical Specification AC230V 240V Phase Suppl Single 230V 240V Minimum Mounting Height From Floor 2 75 Metres Ensure that the unit has cooled and Is Switched off at the mains and unplugged Remove the screws from the unit these are located on the top of the units casing x Carefully open the glass front and place onto a smooth flat surface Minimum Distance From Ceiling 0 5 Metres Minimum Distance From Side Walls 1 5 Metres Unit Dimensions WxHxD 1000W AA A Locate the halogen element into the m4 lampholder push at either end to affix into place Ensuring that the element is not touched with bare hands Replacing the Halogen Element Cont Once the halogen element has been replaced correctly locate the front of the unit back into place and tighten the screws ensuring a water tight seal is achieved Be aaa iE PT IP a r aT a CL ae gh Jooj woy yYBey Buqunow papuawwosay arenes Aare aa Always make Sure that the unit is plugged into a waterproof socket lf in any doubt consult a professional electrician Maintenance amp Cleaning 1 Always ensure that the appliance is disconnected from the mains before any maintenance
Download Pdf Manuals
Related Search