Auxiliary Stands Operating Instructions & Parts Manual
Contents
1. Operating Instructions Parts Manual OMEGA NT Auxiliary Stands Model Capacity 31500 1500 Ib 31501 1500 Ib LH A Model 31500 Model 31501 A This is the safety alert symbol It is used to alert you to potential personal injury hazards Obey all safety messages that follow this symbol to avoid possible injury or death To avoid crushing and related injuries 4 DO NOT use to support or stabilize vehicle Use ONLY under a properly rn secured automotive lift e Leer comprender y seguir las instrucci nes antes de utilizar el aparato El manual de instrucci nes y la informaci n de seguridad deben estar comunicado en lengua del operador antes del uso e No seguir estas indicaci nes puede causar da os personales o materiales SFA Companies http www omegalift com Read this manual and follow all the Safety Rules and Operating Instructions before using this product Printed in China 31500 MO rev 11 07 SAFETY and GENERAL INFORMATION Save these instructions For your safety read understand and follow the information provided with and on this stand before using The owner and operator of this equipment shall have an understanding of the stand and safe operating procedures before attempting to use The owner and operator shall be aware that use of this product may require special skills and knowledge Instructions and safety information shall be conveyed in the operator s native2. f Partffor31500 Partitfor31501 5602 00052 000 6 5701 00006 000 Grease Nipple fo ____T465 00003 000 ON CTS ES ION ONE YEAR LIMITED WARRANTY For a period of one 1 year from date of purchase SFA Companies will repair or replace at its option without charge any of its products which fails due to a defect in material or workmanship under normal usage This limited warranty is a consumer s exclusive remedy Performance of any obligation under this warranty may be obtained by returning the warranted product freight prepaid to SFA Companies Warranty Service Department 10939 N Pomona Ave Kansas City MO 64153 Except where such limitations and exclusions are specifically prohibited by applicable law 1 THE CONSUMER S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS AS DESCRIBED ABOVE 2 SFA Companies SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER 3 ANY IMPLIED WARRANTIES INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE SHALL BE LIMITED TO ONE YEAR OTHERWISE THE REPAIR REPLACEMENT OR REFUND AS PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED 4 ANY MODIFICATION ALTERATION ABUSE UNAUTHORIZED SERVICE OR ORNAMENTAL DESIGN VOIDS THIS WARRANTY AND IS NOT COVERED BY THIS WARRANTY Some states d
3. language before use of these jack stands is authorized If any doubt exists as to the safe and proper use of these jack stands remove from service immediately Inspect before each use Do not use if broken bent cracked or damaged parts including labels are noted Any stand that appears damaged in any way operates abnormally or is missing parts shall be removed from service immediately If you suspect that the stand was subjected to a shock load a load dropped suddenly unexpectedly upon it immediately discontinue use until the stand has been checked by a factory authorized service center contact distributor or manufacturer for list of authorized service centers It is recommended that an annual inspection be done by qualified personnel Labels and owner s manuals are available from manufacturer PRODUCT DESCRIPTION Omega Auxiliary Stands are designed as a means of partial support for and the positioning of vehicle components during their installation removal but not for use in stabilizing or supporting vehicles For use ONLY under a properly secured automotive lift A NEVER use auxiliary stand to support a vehicle a Model Capacity Min Height Max Height Saddle Size Size Net Weight A 29 Ib 1500 Ib 12 53 3 8 78 7 8 5 1 4 x 1 1 2 31501 e 341b 341b PREPARATION Assembly 1 Make sure all parts are present see Fig 1 amp 2 If any parts is missing or damage do not attempt to assemble in
4. o not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state JS SFA Companies 10939 N Pomona Ave Kansas City MO 64153 e OMEGA 888 332 6419 sales omegalift com
5. stall or operate the product Contact Customer service 2 Begin assembly by inserting smaller end of threaded rod 11 through the bottom of upright 4 allowing small end of threaded rod to project out of the top of upright 3 Place bearing 5 over the threaded portion then spin the adjusting handle 7 clockwise onto the threaded rod 4 Saddle 9 can now be fastened by inserting the pin 8 through saddle amp threaded rod 11 5 a For Model 31500 see Fig 1 Insert upright assembly onto the base 1 and secure with bolt amp nut 2 amp 3 provided b For Model 31501 see Fig 2 i Insert upright assembly onto the base 7 with slot in upright facing foot pedal mount and secure using the larger pin washer 8 c clip 3 14 15 ii Insert foot pedal 16 into slot on base 1 and secure with remaining pin washer and c clip 2 12 13 Before Use 1 Verify that the product and the application are compatible if in doubt contact customer support 888 332 6419 2 Before using this product read the operator s manual completely and familiarize yourself thoroughly with the product its components and recognize the hazards associated with its use 3 To familiarize yourself with basic operation turn the adjustable handle Clockwise to raise the saddle Counter clockwise to lower the saddle 4 Inspect before each use Do not use if there are bent broken or cracked components Replace worn or damaged parts with Omega au
6. thorized replacement parts only Saddle Pad 10 Saddle Pad 10 Saddle 9 gt Saddle 9 _ gt Pin 8 gt Pin 8 Grease Fitting 7 Adjusting Grease Fitting naa Ss 7 Adjusting Nipple 6 Handle Nipple 6 Handle Bearing 5 Bearing 5 lt 4 Upright Upright 4 Pin D15mm Se 0 14 Washer M16 yo I T 15 C clip lt 11 Threaded Rod S 11 Threaded Rod 16 Foot Pedal y 52 Nut M8 2 gt 3 Bolt M8x55 Base 1 gt Figure 1 31500 Nomenclature Figure 2 31501 Nomenclature OPERATION This product should NEVER be used to lift or Study understand and follow all printed lower a vehicle materials provided with on this product before use To Raise Do not exceed rated capacity 1 Turn adjusting handle clockwise until saddle contacts load Be sure to center load on saddle 2 On Model 31501 slight upward adjustment can be Center load on saddle made to the saddle height by pressing downward on Do not use to support or stabilize vehicle This the foot pedal This may or may not be necessary stand is intended to provide partial support depending on the application It is provided as a means of vehicle components during removal and of making temporary adjustments on load height installation without using your hands This leaves your hands free to engage handle and control the
7. workpiece Use only on hard level surface Adequately support vehicle before starting repairs Do not lower overhead lift in order to accommodate Use ONLY under a properly secured automotive the stand Contact with the desired vehicle lift component shall only be done by means of the vertical adjustments provided on the stand Do not use adapters or accessories that are not i initially provided initially To Lower No alterations shall be made to this product Make certain that all personnel are clear of the Failure to heed these markings may result in load before lowering Watch and control the rate personal injury and or property damage of descent of the load at all times To lower simply turn adjusting handle counter clockwise MAINTENANCE Periodically inspect each stand Ensure all parts move freely Apply grease to fitting as needed If rust appears sand affected area and cover with suitable utility paint REPLACEMENT PARTS Not all components of the stand are replacement items but are illustrated as a convenient reference of location and position in the assembly sequence When ordering parts give model number serial number and parts description Call or write for current pricing SFA Companies Inc 10939 N Pomona Ave Kansas City MO 64153 U S A Tel 888 332 6419 Fax 816 891 6599 E Mail sales omegalift com Omega Website http www omegalift com Parts List see Fig 1 amp 2 for reference number Re
Download Pdf Manuals
Related Search