Operating Instructions - York Survey Supply Centre
Contents
1. Survey Supply ITN VO24 Flexible Endoscope Nothing else measures up Prospect House George Cayley Drive Clifton Moor York England YO30 4XE ai i Code 28280 Tel 44 0 1904 692723 Fax 44 0 1904 690385 E Mail sales yorksurvey co uk Operating YorkSurvey o MyorkSurvey s Instructions Ref operat98 instructions 15 28280 qxp 05 01 15 York Survey Supply Centre 2015 IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY NOTE THE SAFE OPERA TIONAL REQUIREMENTS WARNINGS AND CAUTIONS USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED FAILURE TO DO SO COULD CAUSE DAMAGE AND OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE USE Safety Instructions e DO NOT use flexible inspection scope if damaged e DO NOT point the distal top towards the Sun or other bright light sources while viewing Serious damage to your eyes may occur e Maintain your scope in new condition as detailed in MAINTENANCE for long service e Be aware of your surroundings environment while using your inspection scope e Account for all tools and parts being used or serviced and do not leave loose parts near moving parts of an engine Introduction Used for inspection of areas generally inaccessible to the naked eye Used for internal inspection of en gines gear train components interior structures of walls and industrial applications Illumination2. Maintenance Instructions Battery Replacement WARNING Make sure the switch is in the off position prior to maintenance and or battery replacement Be careful when removing and re inserting battery pack so as not to strain or pinch the connecting leads See Fig 2 1 Remove the battery housing door with a phillips screwdriver 2 Tilt the battery pack up from the bottom and remove 3 Un clip the connector if required and replace batteries in the pack Dispose of batteries properly 4 Re attach connector and re insert battery pack into bottom of handle 5 Re assemble battery door Do not over tighten screw LIGHTING The LED lamps never need replacement These lamps are designed to be maintenance free for the life of the scope CLEANING AND STORAGE After each use wipe down the distal tip and shaft with a clean dry cloth to remove fluids and residue If needed clean the shaft with a cloth dampened with a mild soap detergent Gently clean the distal tip lens and eyepiece with a cotton bud dampened with a lens cleaner such as isopropyl alcohol Tilt clip against flat of distal check i tip eck to see that clip is seated in recessed area York Survey Supply Centre 2015
3. is pro vided by two solid state LEDs which is controlled by a three position switch giving low off and high output Lighting is powered by 4 x AA batteries located in the handle The adjustable eyepiece allows the user to fine tune focus for a changing object distance The instrument comes in a protective case for storage The instrument also comes with a mirror allowing the user to see 90 to axis of the shaft and a magnet accessory will also pick up approx 1 4lb Specification Model Series VO24 10WW Distal Tip Diameter 10mm Viewing Angle 40 Degrees Viewing Distance 10mm to Infinity Minimum Bending Radius 3 inches Batteries 4 x AA supplied Distal Tip Eyepiece Housing F Shaft Switch Battery Door Ref operat98 instructions 15 28280 qxp 05 01 15 Operating Instructions WARNING Be careful when inserting or removing the scope shaft into and out of the equipment under inspection Be extra careful when using the mirror or magnet accessories The clip may become detached if it is snagged or bumped abruptly See attaching clips Fig 3 Note the location and distance of the object to be inspected and determine the best route to it Bend the shaft to follow the route DO NOT bend any part of the shaft tighter than a 3 inch radius 6 inch diameter DO NOT expose the scope housing to water or other fluids DO NOT insert the scope shaft and tip into locations whose temperature is greater than 70 C
Download Pdf Manuals
Related Search