Electric Halogen Patio Heater Operating Instructions
Contents
1. located on the top of the units casing Carefully open the glass front and place onto a smooth flat surface Locate the halogen element into the Lamp holder push at either end to affix into place Ensuring that the element is not touched with bare hands Replacing the Halogen Element Cont Once the halogen element has been replaced correctly locate the front of the unit back into place and tighten the screws ensuring a water tight seal is achieved 2005 wor 1yBiay Bugunow popu au odej mim Always make sure that the unit is Ss poste eee plugged into a waterproof socket i na if in any doubt consult a professional electrician Maintenance amp Cleaning 1 2 Note Always ensure that the appliance is disconnected from the mains before any maintenance or cleaning is attempted After approximately 100 hours it is recommended that the front cover of the unit is opened and the inside of the glass and reflector is cleaned with a lint free cloth Always make sure that the unit has been allowed to cool before this action is taken if the inside of the glass or the reflector shows a milky colouring this is normal due to internal vapours To clean this open the front cover and clean the glass and the reflector with a lint free cloth All measurements amp Dimensions of this product are approximate and due to the company s policy of research amp development can be subject to change2. Electric Halogen Patio Heater Operating Instructions Please Keep These Instructions For Future Reference IMPORTANT Ensure all instructions are read before use Keep out of reach from children at all times Ensure that your heater is disconnected and has been allowed to cool before cleaning or handling Do not obstruct the heater or cover the heater in any way when the heater is in use Ensure that the mains cable is not touching the outer casing of the heater Ensure that this unit is only switched on once the installation process has been completed e Do not use an extension cable to power this unit as this could cause the unit to overheat and a risk of fire Ensure that you do not touch the heater when in use always turn o ches unit and allow to cool s Ensure that your electricity supply voltage corresponds with the stated voltage for this heater 8 Always ensure that the unit is disconnected from the mains power supply when fitting or replacing the halogen element Ensure that the halogen element has cooled down before replacement s Do not handle the halogen element with bare hands as moisture can shorten the life of the element Do not use this heater with a programmer timer or any other device that switches the heater on automatically since a fire risk axists if the heater is covered ar positioned incorrectly Do not insert any object through any siot or opening in the Danker e Us
3. ers must not disassemble the praducts or change any paris of the heater if the heater is broken please do not use Keep combustible materials such as furniture paper clothes and curtains at least 1 5m from of the heater and away from the sides and rear Do not use this heater in the immediate surroundings of a bath a shower ora swimming pool Technical Specification Voltage ACZZ20V 2460V Total Power kW 30 OOO Phase Supply i Single 220V 240V_ Minimum Mounting Height From Floor Z TA Metres NR oa oe ene o rn o b Minimum Distance From Ceiling 0 5 Metres i Minimum Distance From Side Walls 1 5 Metres Unit Dimensions W x H x D 345x250x170mm ingress Protection IP44 Element Type u att Mounting amp Positioning Remove the mounting brackets by unscrewing the 2 bolts and nuts Ensure that the heater is mounted at a safe distance away from any flammable surface and that the unit is mounted on a non flammable surface Once a suitable location has been selected fix the bracket securely in the desired location Position the heater te your desired angle using the bolts on either side of the bracket Once positioned to a desired angle ensure that the bolts are fully tightened Replacing the Halogen Element Ensure that the unit has cooled and is switched off at the mains and unplugged Remove the screws from the unit these are
4. without prior notice Gala Tent Ltd Unit 1 Park Springs Springvaie Road Barnsley Sth Yorkshire 872 7B www galatent co uk Telephone 0870 4994256 Gala Tent Ltd Unit 1 Park Springs Springvale Road Barnsley Sth Yorkshire S72 7BQ Telephone 0870 4994256 www galatent co uk
Download Pdf Manuals
Related Search