Operating instructions IO-Link interface E30396 704481 / 00 11
Contents
1. Re en delire 24 V DC Operating current of the sensor max 65 mA Connection cable for the sensor US BCD ES a rey ere RS ne 0 4 m Operating temperature EMG EN T0004 ESD ah un an nn eee 4 15 kV EN 61000 4 3 HF radiated csesesssessseersssseeeeeseeees 30 V m 80 1000 MHz EN 61000 4 4 Burst et te te 2 kV coupling clamp EN 61000 4 5 Surge ccscsesssssssssssssssessesessssesserseeen 0 5 kV supply 1 kV signal EN 61000 4 6 HF conducted 0 0 eeccecescsseecseteeetsseeeeeseesees 10 V 0 15 80 MHz2. CE 11 2009 704481 00 ifm electronic Operating instructions IO Link interface E30396 1 Items supplied O Link interface e CD ROM with device drivers and FDT service program ifm Container e Operating instructions 2 System requirements PC or Laptop with Microsoft Windows 2000 Microsoft Windows XP Micro soft Windows Vista e One free USB 2 0 port e 1 MB free hard disk space e CD ROM drive 3 Functions and features The interface connects sensors with communication capability to a PC and pro vides the following options e Reading of the current parameter setting e Parameter setting of the sensor e Reading of the current measured value The interface supports the IO Link and the ifm specific EPS protocol Prerequisite for communication with sensors The ifm program library of the avail able DTM objects it is part of the ifm Container must be installed on the PC 1 The interface with connected sensor requires the complete current pro vided by a USB port gt Therefore only operate it directly on a USB port or on an active USB hub If the interface is connected via a passive USB extension or a passive USB hub it is deactivated The sensor must not be connected to an additional parallel power supply This can destroy the USB port Due to the properties of the Windows operating systems correct function ing of several interfaces connected in parallel cannot be guaranteed 4 Insta
3. llation The PC addresses the interface internally via a virtual COM port to ensure com patibility with older software You must have administrator rights for the installation process Installation gt Insert the CD ROM into the drive gt Connect the interface to a free USB port gt The Microsoft Windows hardware wizard is started gt Follow the instructions of the program Make sure to select the following op tions UK Search for locally available drivers Selection of the driver from the inserted CD ROM Automatic installation of the software 5 Operation gt Connect the interface to the sensor and to a USB 2 0 port of the PC gt After the initialisation time of approx 5 s the interface supplies the sensor with operating voltage gt lf the sensor is addressed via the FDT software the interface determines the correct communication mode and starts the exchange of data If the sensor does not have a suitable communication protocol there is no exchange of data But the sensor continues to be supplied with operating voltage This enables operation for testing or demonstration purposes 6 Technical data NOUEVORAQ eect E inte alle Li alah lee healt eh tat at 5V Current consumption from USB port cccecccesssssecsssesseeesseessseeeseeeseneesneass max 500 mA Supported communication protocols ccee IO Link 1 0 4 800 and 38 400 bits s EPS 19 200 bits s Suppi VOllaGe forthe Sensor LL
Download Pdf Manuals
Related Search