1 Användaranvisning (S) 2 User Manual (GB) 4
Contents
1. i D min ist n Current I2 Time Technical data Measurements 252x168x67 Weight 2kg Ambient Temperature 25 C 40 C Mains Voltage Rated Voltage Current Output Secondary Cables Protection General Tempsense Start inhibit switch 230 Volt AC 50 Hz lt 200V will mean limited effect 12V 30A 14 4V 13 7V_ typical 1 5mx 6mm 1 IP 20 Protected against wrong polarity fuse and short circuit CE certified in accordance with valid EN standards Output fuse 2 x 20Amp Temperature controlled charging optional 12V 100mA present when mains connected optional The 12V type is meant for 12V batteries 6 cell with a capacity of 24 250Ah The 24V type is meant for 24V batteries or two times 12V 12 cells with a capacity of 24 250Ah The charger must only be plugged in to an earthed socket outlet The supply cord cannot be replaced If cord is damaged the appliance should be scrapped This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance 12V Laddaren ar avsedd f r 12V batterier 6celler med en kapacitet pa 24 250Ah 24V Laddaren r avsedd f r 24V batterier alt 2 12V i serie 12celler me2. Anv ndaranvisning S 2 User Manual GB 4 ChAmp laddaren Anv ndaranvisning L s denna anvisning innan laddaren tas i bruk Spara denna anvisning l tt tillg nglig f r anv ndaren av laddaren Vid laddning av batterier bildas det v tgas som kan orsaka explosion ppen eld eller gnistor f r inte f rekomma i n rheten av batteriet St ng alltid av laddaren innan batteriet till eller fr nkopplas IP 20 f r ej uts ttas f r regn Vid laddning avger batterier v tgas som kan ant ndas vid ppen eld eller statisk elektricitet Det r viktigt att s rja f r god ventilation Skyddsglas gon skall anv ndas 0 o o o o o Generellt chAmp laddaren r avsedd f r b de fritt ventilerade Wet och ventilreglerade Dry blysyra batterier Laddaren r liten och kompakt och kan d rf r ofta monteras i direkt anslutning till batteriet i den aktuella maskinen Laddaren som arbetar med avancerad switch teknik ansluts till ett uttag den inbyggda elektroniken styr sedan laddningen enligt en inst lld laddningskurva Under laddningen visas laddningsf rloppet med en statusindikering lysdiod p laddarens panel Elektroniken vervakar ocks laddningen med avseende p laddningstid och temperatur i laddaren f r att kunna begr nsa laddningen t ex vid fel p celler eller vid otillr cklig avkylning av laddaren Onskas specifika laddningskurvor till speciella batterier eller anv ndningsomr den kontakta d v nligen
3. rde ca 1Amp inom den maximala laddningstiden p 20 timmar g r laddaren ver i underh llsladdning Denna skyddsfunktion r till f r att f rhindra verladdning Laddningstiden varierar beroende p batterityp och urladdningsgrad OBS Sl av laddaren eller tag ur n tkontakten innan batteriet kopplas bort Bortkopplas batteriet utan att sla av laddaren skapas gnistor Om n tsladden r skadad skall den bytas ut chAmp Charger User Manual e Read this instruction before the charger is taken into use e Keep this manual within easy reach for the user of this battery charger e Warning Explosive gases prevent flames and sparks Provide adequate ventilation during charging Do not use non rechargeable batteries e For indoor use e Disconnect the supply before making or breaking connection to the battery e When charging batteries explosive gasses may occur ware eye protection General The chAmp Charger is suitable both for Freely Ventilated Wet and Valve regulated Dry lead acid batteries The charger is small and very compact and can therefore easily be fitted close to the battery The charger operates in high frequency and should be connected to a standard 230V mains connection The built in electronics controls the charging process according to the chosen charging algorithm During charging the charging progress is displayed with status indicator LED on the front panel The internal electronics is also controlling the
4. Ink pst llet Installation chAmp laddaren r avsedd f r s v l inomhus som utomhusbruk men f r ej uts ttas f r regn IP20 Den kan anv ndas liggande p bord upph ngd p v gg eller inbyggd i aktuell maskin Batteriet kan efter nskem l vara fast anslutet eller bortkopplingsbart Placera laddaren sa att lufttillf rsel inte blockeras Vid vaggmontering och inbyggnad b r laddaren placeras vertikalt f r att s kerst lla en god konvektion kylning Efter laddning tag ut natkontakten f rst v nta med att ta bort anslutningarna till batteriet tills eventuellt v tgas har ventilerats bort Det kan r cka med en gnista f r att ant nda en explosion Funktion Kontrollera att batterityp och batteristorlek r korrekt att ledningar batterihandske mellan batteri och laddare r r d kabel till pluspol och svart kabel till minuspol Uppladdning startar efter n gra sekunder och statusindikeringen R d lysdiod t nds R d lysdiod r t nd tills batteriet r fullt uppladdad Om laddaren anslutes till ett fulladdat batteri kommer laddaren att g ver till efterladdning under ca 2 timmar som r den kortaste laddningstiden Efterladdning markeras med t nd orange lysdiod Gr n lysdiod t nds n r batteriet r klart anv ndas Underh llsladdning Indikeras av gr n lysdiod sker s l nge batteriet r anslutet Omstart av laddaren kan ske genom att bryta och sluta n tinkopplingen Har laddstr mmen ej n tt inst llt v
5. charging progress with regards to temperature in the charger and time If a fault occurs in some cells or the temperature rises the charging current will be limited If you have a special requirement of charging algorithm or application please contact Your supplier Installation The chAmp Charger is suited for indoor and outdoor use It can be used positioned horizontally on a table or a shelf hang on a wall or as a built in charger in the vehicle or machinery The charger can be with fixed connection to the battery or with conventional connectors Position the charger in such a way that the air supply will not be obstructed When the charger is fitted on a wall or mounted in a vehicle it should be vertical mounted for optimal cooling Function Check that the polarity between the charger and the battery is right Positive to positive and negative to negative Red cable is plus and black cable is minus The charging starts after a few seconds and the status indicator Red LED is lit up Red LED remains on until the battery is fully charged If the charger is connected to a fully charged battery the charger will be charging for 2 hour This is the minimum charging time During this phase the orange led will be illuminated When only green LED is on the charger is kept in maintenance charger and ready to be used Maintenance charging will continue as long as the battery is connected The charger is also equipped with a second safety s
6. d en kapacitet pa 24 250Ah Laddaren maste anslutas till jordat eluttag Natsladden kan inte bytas En skadad natsladd medf r skrotning av apparaten Produkten ar inte mnad att anv ndas av personer inklusive barn med nedsatt fysisk eller mental f rm ga eller som har brist pa kunskap eller erfarenhet om de inte har fatt handledning eller fatt information om hur man anvander produkten av en person som r ansvarig f r deras s kerhet Barn skall vervakas sa att de inte leker med produkten
7. ystem if the total charging time is exceeding 20 hours and current not drop below 1 Amp default the charger turns in to maintenance charge This is to prevent overcharge and can cause damage to the battery The charger will be reset as soon as the charger is switched off and on or if the battery is disconnected The charging time depends on the size of battery and the depth of discharge A freely ventilated battery Wet can be discharged to max 80 and a valve regulated Dry with max 70 OBS Switch off the charger before the battery is disconnected If the battery is disconnected without switching of the charger sparks may be produces This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance Charging algorithms The chAmp charger is designed for freely ventilated and valve regulated batteries All chargers are equipped with app charging curves When Your supplier or place of purchase is informed of battery capacity and type the charger will be delivered with the correct setting Standard IlUoU Voltage U1 A Voltage U3 Max X hours gt Error Phase 1 Y hours Phase 2 Ready Tricle Charge R 7
Download Pdf Manuals
Related Search