User Guide SCOA55 rev A.pub
Contents
1. Se TPL USER S GUIDE VISION Seen cake SCOASS High Power INTRODUCTION This note contains all the instructions and precautions for a safe set up and an optimal use of the product Warning we are not responsible if any of these items below would not be respected and in this case the TPL Vision s warranty shall not apply anymore to this product SAFETY AND OPERATING INFORMATION Class Ill light IP class of the product see the product presentation Operating temperature 0 C a 40 C Power supply 24VDC 10 if this is not respected you may damage the product and or the user may be electrocuted Observe the power supply voltages and terminal plug in Do not modify the product even partially Do not clean while operating Do not cover with a heat insulation or do not lock in a sealed area Do not stare into the beam and follow the instructions below If possible set up a filter to block the product s light radiation between the lighting product and the surrounding worker When the implementation of a filter is not possible provide glasses or an adequate protection mask to workers in order to block the light radiation Forbid or limit as possible direct access to the light source exposure in the axis of radiation Point out a security area to prevent workers from getting too close to the light please follow the NZOR Nominal Zone of Optical Risk recomandations given by TPL Vision upon demand In any case2. ensure that workers around the product are properly protected toward exposure om EF CE Y PACKAGING SHIPPING RECEPTION The product is packaged in our factory using appropriate boxes and packages They are made to avoid any damages by means of regular transportation However a damaged parcel should be reported to the carrier upon receipt and stated officially at its reception as a reserve Then please report by writing to TPL VISION as soon as possible at least within 24 hours after the package reception Any package damaged during transportation will not be taken back or replaced if it has not been reported on the travel voucher and to TPL VISION on time When you open the bag containing the product any cutting blade should be avoided so as not to damage the product All accessories included in the package must be used if necessary do not use other products or equivalent to replace the accessories supplied SET UP PROCEDURE Lighting shall not be settled while the pro duct is powered on For the screws selection not included res pect the following indications Recommended torque 0 5 to 1 5 Nm Using LOCTITE 243 not supplied is recommended 20 rue de St Philbert 44118 LA CHEVROLIERE T l 02 40 56 10 99 Fax 02 40 56 42 89 Rev A copyright TPL Vision 1 2 www tpl vision net ELECTRICAL WIRING 1 Turn off overall system 24 VDC power supply 2 Make all connections power off regarding diagram s belo
3. w T marron brown 3 bleu blue Az noir black T marron brown 3 bleu blue j as noir black Wiring Diagram when using another power drive WARNING The SCOAX is very high power light 12 high power LED inside His design do not accept a continuous mode running please see the sale documentation for proper utilisation or ask directly to TPL Vision technical department His design don t include control current drive don t connect the SCOAX directly to the 24V absolutly use the proper drive advised by TPL Vision CLEANING PRODUCT TURNED OFF Use a soft dry cloth Do not use solvents or chemicals Do not use abrasive cleaning products Rev A copyright TPL Vision 2 2
Download Pdf Manuals
Related Search