AAP 100 MD User's Guide
Contents
1. AAPs e one double spaced AAP Extron USA East Extron EMEA Extron Asia Extron Japan Extron China Extron Middle East 800 633 9876 800 3987 6673 800 7339 8766 81 3 3511 7655 400 883 1568 971 4 2991800 Inside USA Canada Only Inside Europe Only Inside Asia Only 81 3 3511 7656 FAX Inside China Only 971 4 2991880 FAX 1 919 863 1794 31 33 453 4040 65 6383 4400 86 21 3760 1568 1 919 863 1797 FAX 31 33 453 4050 FAX 65 6383 4664 FAX 86 21 3760 1566 FAX 2008 Extron Electronics All rights reserved2. Extron Electronics ex INTERFACING SWITCHING AND DISTRIBUTION User s Guide AAP 100 MD MD Floor Box AAP Bracket Installation Kit 68 720 01 Rev B 11 08 Installation Introduction This guide covers installation of the Extron MD Floor Box AAP Bracket Kit in a Matsushita Denko MD floor box It shows removal of the old bracket and installation of the new bracket AAP unit Installation fey NGRale Installation and service must be performed by authorized personnel only 1 Turn off and disconnect power from all equipment connected to the floor box 2 Remove all cables connected to the portion of the floor box accessible when the lid is open if applicable 3 Remove Screws 3 Open the lid and remove the two screws securing the lid to the floor box 4 Remove the lid from the floor box by sliding the lid toward the hinge to disengage it from the box then put the lid aside 4 Slide Noia If there is no adapter plate or blank plate installed skip to step 8 5 Remove the two screws securing the old adapter plate bracket to the box 5 Remove Screws 6 Slide the adapter plate bracket to the center of the box and disconnect the cables attached to the back side of the adapter plate 7 Remove the old adapter plate bracket and adapter plate unit from the floor box 2 MD Floor Box AAP Kit Installation 8 Attach and secure any single or double Extron AAP for example th
3. e double AAP shown below to the MD AAP bracket with the 4 40 mounting nuts provided 9 Connect cables if applicable to the back of the AAP to be installed 10 Slide Bracket 10 Place the MD AAP bracket into the floor box as shown above routing any cables through the back of the box and slide it in the direction shown 11 Attach with M4 Screws 11 Align the two screw holes in the top of the new AAP bracket with the holes in the box Attach the bracket with the two M4 screws provided MD Floor Box AAP Kit Installation 3 Installation cont d 12 Place the lid on the floor box and slide it away from the hinge to engage the tabs on the box 13 Reinstall the two previously removed screws securing the lid to the box 13 Replace Screws 12 Slide 14 Reconnect power and cables as necessary Optional Extron Architectural Adapter Plates Extron USA West Headquarters 800 633 9876 Inside USA Canada Only 1 714 491 1500 1 714 491 1517 FAX A variety of optional architectural adapter plates for pass through connections may be ordered for the MD floor box AAP bracket Visit the Extron website at www extron com for additional information The AAP bracket can have up to two architectural adapter plates installed depending on the configuration selected The following configurations of architectural adapter plates could be installed in the MD floor box adapter plate e two single spaced
Download Pdf Manuals
Related Search