USER MANUAL CBM-450 UK
Contents
1. SPECIFICATIONS Ane a COUNTRY Channels Operating Modes E1 ITALY SPAIN 40CH AM FM 12 ITALY 36CH AM FM dE GERMANY 80CH FM 12CH AM d2 GERMANY 40CH FM 12CH AM EU EUROPE FRANCE 40CH FM 40CH AM CE CEPT 40CH FM U UK 40CH FM UK FREQUENCIES 40CH FM CEPT FREQUENCIES PL POLAND 40CH AM FM POLISH FREQUENCIES PD POLAND 40CH AM FM POLISH FREQUENCIES FREQUENCY BAND SELECTION PROGRAMMING The receiver has to be programmed on the CB frequency band used in the country where the product is used When radio is switched ON the current programmed frequency band code will be displayed blinking for about 3 seconds To program a different frequency band proceed as follows 1 Turn OFF the radio 2 Press and keep pressed the UP key 6 then turn ON the radio using the OFF VOLUME knob 9 3 The current frequency band code B will blink on the LCD display 4 4 Now select the new desired frequency band code by pressing the UP 6 or DN 5 key 5 Wait for about 5 seconds to confirm and store the new selected frequency band code UK CE CHANNELS SELECTION FREQUENCY BAND U The U band UK CE band includes both UK and CE channels this band is for use in the UK If a UK channel is selected the display 4 will show the channel number B and the indication U If a CEPT channel is selected the display 4 will show the channel number B and the indication C SPECIFICATIONS General Channels Refer2. antenna base and the car body surface Connect the antenna connector D to the antenna outlet 11 located on the rear side of the radio Antenna must be usually placed on the highest part of the vehicle free from nearby metal parts and as far as possible from any possible source of electric or electromagnetic noice The antenna cable must not be damaged in its way to the radio lan o O 2 Parts description A Whip Whip with protective rubber cup B Magnet base Antenna magnet base to be placed on any iron or steel surface with no need to drill any hole on the vehicle body C RG 58 U Cable RG 58 U cable 4m long D RF Connector RCA connector Connect to the antenna outlet 11 located on the rear side of the radio WARNING The Magnet Antenna included in this set has been designed to withstand a vehicle speed of maximum 130 km h no front wind condition Do not exceed this speed when the antenna is installed to prevent antenna from being torn away from the vehicle and causing possible damage to other drivers FREQUENCY BANDS TABLE The receiver INTEK CBM 450 includes an advanced multi standard programmable circuit which allows to program different frequency bands specifications and operating modes in conformity with the regulations in the country where the product is used 9 programmable frequency bands are available as per the below table
3. to the frequency bands table Frequency range 27 MHz Citizen Band Frequency control PLL Operating temperature 10 55 C DC input voltage 13 2Vdc 15 Size Weight 115 L x 43 H x 165 D mm 350 gr Receiver System Double conversion CPU controlled super heterodine IF 1 10 695 MHz 2 455 KHz Sensitivity 0 5yV Audio output 2 5W 8 distortion at 1 KHz Current drain 350mA stand by USER INFORMATION In accordance with art 13 of the Legislative Decree of 25th July 2005 no 15 Implementation of Directives 2002 95 EC 2002 96 EC and 2003 108 EC relative to reduction of the use of hazardous substances in electrical and electronic equipment in addition to waste disposal The crossed bin symbol shown on the equipment indicates that at the end of its working life the product must be collected separately from other waste DEA The user must therefore take the above equipment to the appropriate differentiated collection centres for electronic and electro technical waste or EE return it to the dealer when purchasing a new appliance of equivalent type in a ratio of one to one Appropriate differentiated waste collection for subsequent recycling treatment and environment friendly disposal of the discarded equipment helps to prevent possible negative environmental and health effects and encourages recycling of the component materials of the equipment Illegal disposal of the product by the user will be punished by applicati
4. INTEK CBM 450 27MHz PROGRAMMABLE MULTI STANDARD MOBILE CB MONITOR ROAD WATCHER Thank you for purchasing this new CB Monitor receiver You will be pleased to discover the multiple advantages of been informed of What s going on the road while you are driving you vehicle by listening to the interesting radio communication among truck drivers and other Citizen Band users A great way to improve your traveling and driving confort Please carefully read this owner s manual before using the product Before using this receiver please check that the radio has been programmed on the frequency bands used in the country where the product is used If not please change the frequency band programming as it is described in this owner s manual This receiver is factory pre programmed on the CE European frequency band CEPT 40CH FM CONTENT OF THE PACKAGING Please check that all the following items are contained in the packaging main unit receiver car mounting bracket with accessories hardware knobs etc mobile antenna with magnet base and connector owner s manual O 2 INTEK CBM 450 CB MONITOR ROAD WATCHER FRONT PANEL 1 A F Key AM FM selection The AM FM operating mode selection is possible only when both the AM and FM modes are available in the selected band otherwise the AM FM selection is not possible 2 ANL Key A
5. LATION Before installing the main unit in the vehicle check and select the most convenient location in order that the radio will be easy to reach and comfortable to operate without disturbing or interfering with the vehicle drive Use the supplied bracket and hardware to install the radio The bracket screws must be well tightened in order not to become loosen with the vehicle vibrations The car mounting bracket can be installed over or below the radio and the radio may be inclined as desired according to the specific type of installation under dashboard or track cabin roof installation Installation of the Main Unit Before connecting the radio to the vehicle electric system make sure that radio is switched off with the OFF VOLUME 9 knob completely turned counter clockwise at OFF position Connect the lighter adaptor plug 12 to the 12VDC socket of the vehicle Fuse is located inside the lighter adaptor plug To replace the fuse unscrew the cap of the plug remove the fuse and the spring then reinstall all parts by first inserting the spring and then the new fuse Installing and connecting the supplied mobile Magnet Antenna A 27 MHz mobile antenna with magnet base and 4m RG 58 U is included in the kit Please pay attention to correctly placing the magnet antenna on the vehicle top The magnet antenna must be firmly attached to the vehicle metal body Before attaching the antenna on the car body carefully clean both the bottom side of the
6. on of the administrative fines provided for by the legislative decree no 22 1997 article 50 and following of the legislative decree no 22 1997 DECLARATION OF CONFORMITY DECLARATION OF CONFORMITY With the present declaration we certify that the following products INTEK CBM 450 comply with all the technical regulations applicable to the above mentioned products in accordance with the EC Directives 2006 95 EC 2004 108 EC 99 5 EC CB Receiver EN 300 433 1 2 EN 300 135 1 2 EN 301 489 1 EN 301 489 13 EN 60065 INTEK S R L Via G Marconi 16 20090 Segrate Italy Tel 39 02 26950451 Fax 39 02 26952185 E mail intek com intek com it Type of product Details of applied standards Manufacturer dr Vittorio Zanetti Segrate 19 12 2011 c o g co BQ
7. t the operating channel By keeping a key pressed the quick channel selection mode will be enabled 7 BUSY Indicator This green color LED indicator is lighted when radio is receiving one communication and the squelch is open radio is not in the automatic mute mode 8 AS SQUELCH Control SQUELCH CONTROL SQUELCH manual adjustment The SQUELCH control allows to silent the receiver by cutting the background noise when no signals are received Turn the knob clockwise until the background noise is cut Turn the knob counter clockwise SQUELCH opening in order to listen to the weakest signals AS CONTROL SQUELCH fixed setting The AS function allows to automatically silent the receiver avoding the SQUELCH manual adjustment A fixed SQUELCH threshold is factory pre set To enable the fixed SQUELCH function turn the knob fully counter clockwise to the AS position until a click noise is heard 9 OFF VOLUME Control Switches radio ON and OFF and adjust the receiver volume to the desired level To adjust the receiver volume if no signals are received on the channel open the SQUELCH and then adjust the receiver volume using the background noise as a reference REAR PANEL 10 EXT External Speaker Jack Connection for external speaker optional 11 ANTENNA Connector Antenna connector Refer to the section INSTALLATION 12 13 2VDC POWER CORD 13 2VDC power cord input The power cord is complete with lighter adaptor plug INSTAL
8. utomatic Noise Limiter Enable the ANL Automatic Noise Limiter function to reduce electric or electromagnetic noise or interference on the used channel The ANL icon D is lighted to confirm that the ANL function is enabled Press again the ANL key 2 to disable the function 3 EMG key Emergency Channels Press to quickly access to the two pre programmed emergency channels CH9 CH19 Each time this key is pressed radio will select CH9 then CH19 then again the normal operating channel CH9 and CH19 are the two most used channels by truck drivers 4 LCD Display Large size LCD display with blue color backlight function for best readability in darkness It indicates the operating channel number the operating mode all the programmed settings and all the enabled functions DS e HEE AL amanca LCD DISPLAY A AM icon The icon A is lighted when radio is set to the AM operating mode B Channel Number It shows the channel number or the frequency band ID code C Digital Signal Meter 5 bar Signal Meter C indicates the strength of the received signal from SO to 9 30 in the receive mode D ANL Icon The Icon D is lighted when the ANL Automatic Noise Limiter is enabled E HL Icon Not available on this model F ATT Icon Not available on this model G FM Icon The icon G is lighted when radio is set to the FM operating mode 5 6 Down Up Keys Press to selec
Download Pdf Manuals
Related Search