User Manual - produktinfo.conrad.de
Contents
1. OF ELECTRONIC SHOCK DO NOT REMOVE COVER NO USER SERVICEABLE PART INSIDE2. BPA30 User Manual Introduction Thank you for inviting BPA30 into your music life The BPA30 is a portable battery powered amplifier With the BPA30 you can easily perform your music outside with great tone In order to achieve the most performance and safety operation please read this user manual in detail 1 Features Two input channels for connecting microphones high and low Z and instruments CD input jacks for connecting a CD or tape player drum machine or other background source Headphones jack for monitoring Internal rechargeable power supply provides a minimum of 8 hours normal playing time the recharging time is no more than 6 hours Two color power status LED red indicates low battery yellow indicates battery is okay Tuned port cabinet for extended bass response 8 woofer and 2 Piezo tweeter for full range sound with clear highs Rubber feet on three different sides for positioning as either a low angle monitor high angle monitor or upright speaker 2 Front panel BPA 30 McLELLAND 1 Input 1 Volume This jack accepts a microphone high or low Z or a instrument 2 Input2 Volume This jack accepts a microphone high or low Z or a instrument 3 Equalization Low Low Mid High Mid High These knobs are used to adjust the level in low low mid high mid high frequencies 4 CD Input This jack accepts sources from a CD player a tape player a drum machine or any other similar source to the ampli
3. a mic into Input 1 and an instrument such as guitar into Input 2 and a drum machine CD player or tape player into the Insert jack The outputs of the CD tape player must be summed to a mono signal with a 1 4 plug as shown 5 Specification Output Power Rating Input Impedance 30W RMS 10 THD 8 ohms 13 6VDC in 1M ohm Maximum signal accepted Channel 1 6V peak to peak Channel 2 12V peak to peak Gain Channel 1 64dB Channel 2 56dB w Gain switch out 86dB w Gain switch in Sensitivity Channel 1 9mV RMS Channel 2 20mV RMS w Gain switch out 7mV RMS w Gain switch in Line In Insert 3V RMS Tone CHANNEL 1 15dB 600Hz EQS CHANNEL 2 Low 12 5dB range 80Hz Mid 18dB range 850Hz High 13dB range 6kHz Insert Jack Tip Line In Ring Line Out Sleeve Ground Speaker Woofer Crate Custom Design 8 8 ohm 50 watt 1 voice coil Tweeter 2 Piezo 8 ohm 50 watt Power Requirement Internal 12 volt DC power supply DC adapter for use with 120VAC Optional 12V vehicle lighter adapter Dimension 17 W 12 1 2 H 12 1 2 D 17 lbs Safety instruction Caution To reduce the risk of electric shock do not remove the cover no user serviceable parts inside Refer servicing to qualified service personnel Warning To reduce the risk of fire or electronic shock do not expose the appliance to the rain or moisture Read
4. fier by means of a shielded signal cable 5 Headphones Use this jack to connect a pair of stereo headphones to the amplifier The internal speaker is disconnected when the headphones jack is used 6 Power Use this switch to turn the amplifier on or off 3 Rear panel McLELLAND BPA 1 DC Charger Plug This jack accepts a 15 VDC charger to recharge the battery power switch off or to supply power to the amplifier while playing power switch on 2 DC CIGARETTE LIGHTER ADAPTER 12 VDC This jack accepts a small round connector of the optional 12 volt car adapter to power the amplifier from a vehicle instead of the internal battery This connect doesn t supplied 15 volt charger to this jack be careful 4 Suggestion Setting Application 1 Plug a mic into Input 1 and an instrument such as a guitar into Input 2 Any types of pickups are available When any effect devices are needed please connect the device and Insert jack or between the microphone and Input1 Note that the effect is applied when the device is connected into the Insert jack INPUT 1 Application 2 When using a drum machine CD player or tape player plug the one device into the Input 1 or plug multi devices into a combiner adapter as shown Application 3 Plug a mic into Input and a CD or tape player into Input 2 The outputs of the CD tape player must be summed to a mono signal with a 1 4 plug as shown Application 4 Plug
5. instructions All the safety and operating should be read before the appliance is operated Retain instructions All the safety and operating should be read before the appliance is retained for future reference Heed warning All warnings on the appliance in the operating instruction should be adhered to Follow instruction All operating and user instruction should be followed Water and Moisture Do not use this appliance near water such as bathtub washbowI kitchen sink laundry tub wet basement or near a swimming pool Heat Guard against the heat sources such as radiators stoves or other equipments radiate heat Power source The appliance should only be supplied with the type described in the operating instruction or marked on the rear panel of the appliance Cleaning The appliance should be cleaned only as the instructions recommended by the manufacturer Avoid objects or liquids entry Care should be taken so that objects or liquids will not be dropped into the enclosure Damage requiring service In the following circumstances repairs should be performed only by qualified service personnel 7 AC power cord or AC socket is damaged 8 Any object has fallen into the appliance 9 Liquid is spilled into the appliance 10 The appliance has been exposed to rain 11 The appliance dose not appear to operate normally 12 The appliance has been dropped or the enclosure is damaged CAUTION TO REDUCE THE RISK
Download Pdf Manuals
Related Search