2009-11, User manual FA1
Contents
1. User manual FAQ 2222 oannaam updated 11 2009 Definition of Full Automatic FA1 Using the Full Automatic FA1 loose bolts can be tightened with a single tool When the bolting is done an optical and acoustical signal comes up The Full Automatic works with following tools Stealth without valves Avanti MXT XLT XLCT and previous models Change of tools or torque pressure With the beginning of a new bolting job with a different torque or a different tool the pump has to be setup every time on these For doing a new setup the pump resp the electronic itself has to be switched off and then on again At the 400V edition the switch built into the electronic box only switches off the electronic itself It does not disconnect the pump from mains The setup has to be done as described after every restart Operating temperature The pump resp the oil needs to be above 20T 68f for secure and correct automatic operation A safety check inhibits the automatic operation below this temperature This safety check is indicated by a blinking of the lamp in the electronic box When the pump does not react on pressing the automatic button A the temperature is too low Then the pump has to be warmed up using the manual mode If it is high enough the lamp shines constantly 1 Tool Full Automatic For operating the pump following steps are to be accomplished Adjusting the torque pressure and measuring the tool After switching on the pump thi2. s setup is possible Connect the tool to the pump Do not apply it to the screws Vent the system by driving back and forth several times Press and hold Automatic button A The pump will build up pressure and the red lamp within the remote control begins to shine Adjust the torque pressure and fixate it Keep the Automatic button A pressed and press the Manual button f about one second additionally to confirm the torque pressure Thereafter the pump will measure the tool and light up the green lamp when the setup is completed Tightening using the automatic mode Place the tool onto the next screw Press and hold Automatic button A The loose bolt is being tightened up to torque pressure When the bolting is done a horn sounds and the green lamp within the remote control comes up The tool can be placed onto the next screw Re adjustment the torque pressure and measuring the tool The pumps automatically re adjust the changing of the done adjustment while tightening a flange In special cases this automatical re adjustment is not possible Ensuring a safe work the pumps signals a necessare re adjustment by double short horn signal and switching the red lamp on In this case the operator has to place the tool onto the ground and adjust the torque pressure and measure the tool like shown above Tightening of pre torqued screws Pre torqued screws can be tightened using the Full Automatic 2 2
Download Pdf Manuals
Related Search