USER GUIDE herborizer
Contents
1. 0 sessions using BIO Limpuro cleaning solution perfectly suited it allows cleaning without brushing Leave to act with hot water for half an hour rinse If you do not have Limpuro cleaner use a solvent or alcohol for the bowl and body rinse abundantly with clean water Do not use washing up liquid with hot water ineffective on resin deposits2. Herborizer basic Users guide AP Pack contents herberizer e 1 Injector B e 2 Bowl with stainless steel screen e 3 Power supply adaptor e 4 Power cord e 5 Stirring rod Assembly We advise careful manipulation of all glass components and to ensure a permanent location for the installation of you Herborizer prefer a site against a wall to a coffee table for example in order to avoid tripping over the power supply cord after a successful vaporization session The conical glass joints are extremely precise to disassemble twist to release before pulling apart Put a little cold water in the body of the Herborizer fill just above the holes the water filters plant particles present in the vapour whilst at the same time cooling it With the model Tube it is also possible to use crushed ice or ice cubes alternatively place the water filled body in a refrigerator For the model Sphere install the inhaler nozzle or the flexible optional extra Place the bowl containing the screen on the body introduce your finely ground dried herbs in the bowl with a grinder optional extra completely cover the screen Then place the injector over the bowl The Sphere models also have an inhaler tube or flexible optional extra Connect the injector to the mains adaptor or the cigarette lighter Be careful to ensure good connections failure to do so may result in serious damage to the connectors Leave for approximately 10
3. minutes to preheat before using Once a sufficient temperature is reached the Herborizer can be left on for several hours which permits regular usage without preheating Instructions for use WARNING to avoid damage to the injector NEVER BLOW into the Herborizer For maximum efficiency inhale gently and slowly the vapour will appear after 2 3 inhalations If you do not inhale the herbs will not be consumed the heat being evacuated at the top of the injector The amount of vapour given off depends upon the quality of herbs and resin content A very resinous herb needs a lower vaporization temperature than a herb with less resin After several inhalations remove the injector and stir the herbs with the stirring rod or spoon in order to ensure a complete vaporization of the herb If you wish to use essential oils and resin first place on a bed of dried herbs The end of a vaporization session is reached when when the green herb colour yellows the taste is unpleasant and there is no more vapour To change the herbs remove the hot injector and place on its stand optional extra or on a wooden or glass board avoid all other materials which may burn or melt or damage the injector Empty the bowl after each session it is easier when warm the spoon can be used to remove the stainless steel screen To avoid blocking clean regularly with a small brush Cleaning Clean the Herborizer completely and regularly approximately every 1
Download Pdf Manuals
Related Search