Home

Operating instructions Remote control

1. SoOLA ECS Operating instructions Remote control Cleantecs To switch on the unit press and hold the green button on the transmitter for around 2 seconds The LED check will flash rapidly when the radio connection to the receiver has been established To switch off just press the red button briefly and the LED check will go out after around 2 seconds The transmitter automatically switches itself off as soon as it goes out of range Ten minutes before the battery becomes empty the LED check will begin Cleantecs to flash slowly The battery must be charged while ensuring an uninterrupted supply of power and at a room temperature of 9 10 oo 6 Connect the power supply which is supplied with the charging station The power indicator lamp will then go on Plug the transmitting unit into the charging station and the battery charging process will begin Check the status of the indicator lamps on the station to confirm whether the charging process has actually started Signals to indicate the charge level of the battery are shown via the power and status indicator lamps POWER STATUS CHARGING STATE On Off The completion of the charging process is indicated via the transmitting unit on the station The battery is 100 charged In the event of very high gt 45 or low lt 0 temperature conditions the battery will indicate that charging has been suspended to protect the battery due to the extreme temperatures in
2. erials which should be reused Therefore please dispose of unwanted devices via suitable collection schemes Hofackergasse 3 D 89250 Senden Tel 49 0 7307 9265 O Fax 49 0 7307 9265 20 Email info cleantecs de Internet www cleantecs de Cleantecs
3. volved Charging will resume when the temperature is within the approved temperature range once again Off On The battery is in the rapid charging phase The battery can be swiftly charged to up to 70 of its overall capacity Time required around 2 5 hrs On On The battery is being charged slowly The battery is charged in slow mode between 70 and 100 of its capacity Time required around 2 5 hrs If you forget to charge plug the transmitting unit into the charging station for 10 15 minutes after which the capacity will last for around 5 hours operation To extend the service life of the battery we recommend always charging the battery fully Important The battery must be charged every 6 months even when the device is not in use Cleantecs gt x p Type of radio remote control system Mito Working range UHF Working frequency range ISM 868 0125 869 9875 MHz Modulation type GFSK Hamming distance gt 10 Working temperature 20 55 C Storage transport temperature 20 55 C Effective range 250 m Time of passive stops lt 2 s The guarantee is invalidated if the customer a attempts to repair the product sold by himself b fails to report any defects found to the seller immediately c if the product is damaged in an accident The packaging materials are recyclable Please do not dispose of the packaging with other household refuse recycle it Unwanted devices contain valuable recyclable mat

Operating instructions Remote control

Contents

Download Pdf Manuals

Related Search

Related Contents