POWERNAIL PowerPalm Instructions / Assembly
Contents
1. PowerPalm Pneumatic Nailer The PowerPalm Nailer is used to drive 16 or 18 gage Powercleats in those hard to reach places where traditional flooring nailers can t reach finishing rows starter rows end strips transitions etc SAFETY WARNINGS amp CAUTIONS e Always wear safety glasses with side shields that meet ANSI Z87 1 requirements when operating the tool Make sure all others in work area wear safety glasses e Always wear hearing protection to protect your hearing from noise Prolonged exposer to loud noise can result in hearing loss e TO LOAD Point tool in a safe direction lightly place one nail in the guide bushing tip A magnet in the bushing will hold the nail DO NOT PUSH THE NAIL Pushing the nail too deep into the tip can result in activating the tool e Only connect air to an unloaded tool to avoid accidental discharge and always keep tool pointed in a safe direction e Never point tool at yourself or others in the work area Always keep tool pointed in a safe direction at all times e Use only clean dry regulated air not to exceed 70 100 psi e Never use oxygen or other bottled gasses explosion may occur e Always DISCONNECT THE AIR SUPPLY before making any adjustments repairing clearing jams or when the Nailer is not in use Do not use on scaffolding or ladders and disconnect Nailer from air supply when transporting between installation areas e Never attach the female end o2. f a quick disconnect to the Nailer This will trap air inside the Nailer and permit it to be discharged Only the unrestricted male connection should be attached to the Nailer OPERATING THE TOOL Your Air Palm Nailer is an Automatic Hammer It has no trigger it starts driving when the rod of piston assembly presses against the fastener s head It will automatically stop when the fastener s head no longer touches this piston rod The operator needs only a slight amount of pressure to activate the tool Do not force the tool Powernail Power Palm Nailer Tool Tips 1 Place one nail in the guide bushing 2 Do not push harder than necessary to activate nailer 3 Nailer will drive amp set nail with minimal pressure 4 For exotic amp dense wood 1 1 2 length nails work best 5 Sub floor must be solid for nail to drive amp set correctly Use the palm nailer to nail down your starter rows Be sure to leave the recommended expansion space between the wall and your starter rows Use the palm nailer for 2 3 rows or until you are far enought from the wall where you can start using a Powernailer Use the palm nailer on the last couple of finishing rows where a Powernailer can t be used
Download Pdf Manuals
Related Search