LightShow 37405 Instructions / Assembly
Contents
1. 59659 48362 38418 48224 48225 70231 70232 59561 59716 59916 38483 36389 38656 Visit WWW GEMMY COM for more information 2015 GEMMY INDUSTRIES CORP 117 WRANGLER DRIVE SUITE 100 COPPELL TX 75019 U S A 1 877 250 9032 MADE IN CHINA PRINTED IN CHINA 37297 37900 59460 48229 384842. INSTRUCTIONS SAFETY WARNING Remove all plastic fasteners and tags These are part of the packaging and should be discarded SAVE THESE INSTRUCTIONS This manual contains important safety and operating instructions for power units WARNING ELECTRIC PRODUCT Keep away from children Not recommended for children under 3 years of age As with all electrical products precautions should be observed during handling and use to reduce the risk of electric shock If the supply cord is damaged it must be replaced by the manufacturer its service agent or similarly qualified persons in order to avoid a hazard Strobe lights have been known to trigger seizures in people with photosensitive epilepsy WARNING The light is very bright Do not shine directly into eyes IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS FURNISHING WARNING TO REDUCE THE RISK OF BURNS FIRE ELECTRIC SHOCK OR INJURY TO PERSONS READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1 Do not secure the wiring of the product with staples or nails or place on sharp hooks or nails 2 Do not let lamps rest on the supply cord or on any wire 3 Do not close doors or windows on the product or extension cords as this may damage the wire insulation 4 Do not cover the product with cloth paper or any material not part of the product when in use 5 Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use When products are
3. at may cause undesired operation CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority fo operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the 3 following measures e Reorient or relocate the receiving antenna e Increase the distance between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help WARNING CAN ICES 3 B THESE INSTRUCTIONS ARE FOR THESE ITEMS 36026 36629 35395 35475 35477 35560 37403 37404 37405 37406 37407 37551 37901 37902 59562 59678 59679 59459 59658
4. be removed Discard product if attachment plug is damaged 1 Grasp plug and remove from the receptacle or other outlet device Do not unplug by pulling on the cord 2 2 Open fuse cover Slide open the fuse access cover on top of the attachment plug towards blades See illustration 3 Remove fuse carefully 4 Replace fuse only with 5 Amp Max 125 Volt fuse provided with product 5 Close the fuse cover Slide closed the fuse access cover on top of the attachment plug OPERATING DETERMINATIONS This product was designed for indoor and outdoor use Do not shake the device Avoid brute force when operating the device Keep away from direct insulation particularly in cars and heaters Do not permit operation by persons not qualified to operating the device Most damages are the result of unprofessional operation Never use solvents or aggressive detergents in order to clean the device Rather use a soft and damp cloth Please use the original packaging if the device is to be transported Unauthorized modifications on the device are unacceptable due to safety reasons If this device is operated in any way different from the ways described in this manual the product may suffer damages and the guarantee becomes void OPERATION Insert the plug into socket Set this device as a projector Extract the plug if not in use Be careful with the power cord WARNING e The device is for indoor and outdoor use e Suitable for out
5. door use e Please keep away from heaters and other heating sources IMPORTANT Damages caused by the disregard of this user manual are not subject to warranty The dealer will not accept liability for any resulting defects or problems Keep away from heaters and other heating sources If the device has been exposed to drastic temperature fluctuation e g after transportation do not switch it on immediately Leave the device switched off until it has reached room temperature Please note that damages caused by manual modifications on the device or unauthorized operation by unqualified persons are not subject to warranty Keep young children and amateurs away from the device USE AND CARE INSTRUCTIONS 1 Before using and reusing inspect the product carefully Discard any products that have cut damaged or frayed wire insulation cords cracks lamp holders or enclosures loose connections or exposed copper wire 2 When storing the product carefully remove the product from wherever it is placed including trees branches or bushes to avoid any undue strain or stress on the product conductors connections and wires 3 When not in use store neatly in a cool dry location protected from sunlight WARNING This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference th
6. lly in the outlet reverse the plug If it still does not fit contact a qualified electrician Do not use with an extension cord unless plug can be fully inserted Do not alter or replace 14 Read and follow all instructions that are on the product or provided with the product CAUTION To reduce the risk of fire and electric shock 1 Do not install on trees having needles leaves or branch coverings of metal or materials which look like metal 2 Do not mount or support wires in a manner that can cut or damage wire insulation SAVE THESE INSTRUCTIONS FEATURES Plastic housing with 4 pieces high power LEDs UL power cord operated Easy installation High quality long product life TECHNICAL SPECIFICATIONS Light sourcing 1W LED 4 T20VAC 60Hz 0 076A 6 3W ASSEMBLY INSTRUCTIONS 1 Assemble the light stake parts A amp B as shown in illustration 1 Push the A and B parts together until tighten the screws 2 Push A through the circle insert the grooves of projector and tighten the circle then adjust the angle of projector illustration 1 3 Plug power cord into standard wall socket See illustration 2 4 Unplug when not in use USER SERVICING INSTRUCTIONS Fuse Replacement WARNING Risk of Fire Replace only with same size and type of fuse i W N fe WARNING Risk of Fire Do not replace the attachment plug Contains a safety device fuse that should not
7. used in outdoor applications connect the product to a Ground Fault Circuit Interrupting GFCI outlet If one is not provided contact a qualified electrician for proper installation 6 This seasonal use product is not intended for permanent installation or use 7 Do not mount or place near gas or electric heaters fireplace candles or other similar sources of heat 8 Unplug the product when leaving the house when retiring for the night or if left unattended 9 This is an electric productnot a toy To avoid risk of fire burns personal injury and electric shock it should not be played with or placed where small children can reach it 10 Do not use this product for other than its intended use 11 Do not hang ornaments or other objects from cord wire or light string 12 This product employs overload protection fuse A blown fuse indicates an overload or short circuit situation If the fuse blows unplug the product from the outlet Also unplug any additional strings or products that may be attached to the product Replace the fuse as per the user servicing instructions follow product marking for proper fuse rating and check the product lf the replacement fuse blows a short circuit may be present and the product should be discarded 13 This product has a polarized plug one blade is wider than the other as a feature to reduce the risk of electric shock This plug will fit in a polarized outlet only one way If the plug does not fit fu
Download Pdf Manuals
Related Search