Holdrite QS-120-H Installation Guide
Contents
1. FTUBBARD ENTERPRISES HOLD i Converting Makeshift Methods into Engineered Solutions INSTALLATION INSTRUCTIONS Caution Wall coverings may conceal electrical wiring or pipes which may cause damage or serious injury if punctured by drills or fasteners Unless you are confident that there will be no interference from such obstacles we recommend that you seek qualified help when installing this product INSTALLER WEAR GLOVES amp PROTECTIVE EYEWEAR WHEN INSTALLING THIS PRODUCT Caution Strap coil is under tension Box Contents BOX CONTENTS 4 Straps 4 J Clips 4 Lag bolts 1 4 x 2 1 2 Self drilling with 1 4 washers 2 3 8 bolts washers nuts TOOLS NEEDED e 3 8 socket or wrench for tightening at wall e 9 16 wrench for tightening strap and J Clips Optional Drill with 1 8 drill bit Check the water heater If the water heater is not a zero clearance unit as specified on the rating plate see instructions inside box on how to build a spacer Select location for water heater Figure A The best place to locate your water heater is directly in front of a 2 x 4 wall stud See Figure A Figure B The straps must be installed in the upper and lower 1 3 of the water heater The lower strap must be at least 4 above the water heater s controls See Figure B Mark the wall studs on both sides of the water heater where you will install the straps Drill 1 82. pilot holes if desired QUICK SILVA WATER HEATER RESTRAINT BRACKETS channeled Lag It is not necessary to pre drill a pilot hole for the lag bolt Figure D Select one strap Install one J Clip per 4 Figure E Strap A Hold strap A so that the J Clip is in the approximate center of the water heater See Figure C Select a mounting hole that best aligns with the pilot mark on the stud secure the end of the strap to the stud witha 1 4 x 2 1 2 lag bolt and washer See Figure D Strap B Install strap B See Figure E on the opposite side of the heater select a mounting hole which allows a few inches of strap B to pass behind Strap A and secure Strap B to the wall Insert a J Clip into the slots of Strap B The longer side of the J Clip must be towards the end of the strap so that it is approximately 3 from the J Clip on Strap A when the two J Clips are pulled together snugly See Figure F Hint If Strap A is too long simply re position the J Clip then bend the strap behind the J Clip as shown in Figure G Secure the two J Clips together with 3 8 carriage bolt nut and washer and tighten Repeat the entire installation process for the second pair of straps using the same hole and slot positions as the first installation If necessary trim strap ends at the wall Installation Complete DSA APPROVED Hubbard Enter
3. prises 2560 Progress Street Vista CA 92081 800 321 0316
Download Pdf Manuals
Related Search