EcoSmart ECO 8 Instructions / Assembly
Contents
1. QUICK INSTALL GUIDE Models Eco 8 11 This is a quick install reference guide you must follow the complete installation ec O instructions and homeowners manual included with the unit SMaRT IMPORTANT SAFETY INFORMATION TAREE RD Netra ste As when installing or using any high voltage electrical appliance basic safety precautions should always be followed Under no circumstances should you attempt to clean install inspect repair disassemble or otherwise service this water heater without first shutting off all power to the unit directly at the breaker box SERIOUS BODILY INJURY OR DEATH COULD OCCUR IF YOU IGNORE THIS WARNING THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN AND PLUMBER IN ACCORDANCE WITH ALL NATIONAL STATE PROVINCIAL AND LOCAL ELECTRICAL AND PLUMBING CODES PLEASE READ THESE INSTRUCTIONS THOROUGHLY AND COMPLETELY BEFORE INSTALLATION AND BEFORE USE FAILURE TO DO SO COULD CAUSE PROPERTY DAMAGE OR SERIOUS PERSONAL INJURY OR DEATH AND VOID YOUR WARRANTY THIS WATER HEATER MUST BE INSTALLED BY A LICENSED ELECTRICIAN AND PLUMBER PROOF OF INSTALLATION MUST ACCOMPANY THE WARRANTY CARD Plumbing Connection Electrical Connection The Eco 8 series is supplied with 1 2 NPT and All units are supplied with 1 sets of wires and a Eco 11 CF DO NOT weld or use TEFLON tape or ground These wires must be installed to an inde PASTE Water heater hoses are strongly pendent double pole breakers as per MODEL specs recomme2. nded Connect the COLD water supply below line to the right side of the unit and the HOT water line to the left side of the unit 1 DOUBLE POLE 60 Amps Breaker HOT WATER OUT ej Signe COLD WATER IN Check all wires to make sure they are securely fas ten and tight Before turning the power ON make a sure the system has been flushed as required in the plumbing section When the unit is powered up turn i the control knob to turn ON the GREEN LED indicator Qa light You can set or adjust your temperature at any mi a time between 80 F 125 F 26 51 Once both water lines are fastened and secured you MUST run water through the unit for at least 2 minutes to FLUSH any air pockets purging in e the lines it is recommended that all faucets Showers etc be run Failure to follow this step can cause permanent damage to the unit This proce ELECTRICAL SPECIFICATIONS dure MUST be performed before any electrical Required Max Amp AWG Cable power is turned on Breaker Draw Installation Question Eco8 1x 40ADP 08 1 set 877 474 6473
Download Pdf Manuals
Related Search