none 0244808012 Instructions / Assembly
Contents
1. from outside of garage door a number of places around the jamb Connect the marks with a straight edge then open door again 3 Measure top opening from side to side and cut Garage Door Thermo Stop ends square with fine tooth power or hand saw 4 Place grooved side against Jamb and inner edge where hard vinyl joins weatherstrip along marked lines Nail in place with 6d galvanized finishing nails in the pre punched nail guides or 8 on center 5 Measure and cut each piece to fit from top piece to floor With grooved side against Jamb position nail as directed 6 For a good drainage and overlap trim side stop pieces where the soft vinyl weather stripping meets the top stop with scissors at a 45 angle www royalmouldings com2. 5 Garage Door VERANDA pots Trim Solutions Veranda Garage Door Trim Solutions The low maintenance energy efficient solution that insulates better than wood or aluminum garage trims Royal Cellular Vinyl offers a quality solid outer skin and a strong durable cellular core Thermo Stop technology deflects moisture heat dust and cold from edges of a garage door creating a lasting solution e Lifetime No Rot material e Ready to install no further painting necessary Before e Cuts and nails better than wood with standard woodworking equipment ey Mould e Reduces energy cost while sealing ak out water dust and bugs Garage Door h Thermo Stop e Moisture and termite proof After Royal Cellular Vinyl VERANDA Gar cage Door Brick Mould Jamb Garage Door Thermo Stop Available Colors White Brown Sandstone Bronzetone Available through special order Repainting Veranda comes with a factory applied Readi Finish which requires no painting for protection Desired custom finishes can be achieved using oil based or latex paints To maintain warranty for custom colors in darker shades use of paints with VinylSafe Technology is recommended Dark Colors are considered any color that falls within the lightness L value of 56 to 0 noting that 100 is white and O is black For more information on painting dark colors call 800 368 3117 800 368 3117 Tim Solutions Tips
3. on Installation Jamb and Brick Mould 1 Remove old Jamb Brick Mould and Garage Door Thermo Stop with a pry bar or hammer 2 Measure the top opening from side to side and cut Jamb to fit with a fine tooth power or hand saw 3 Install top Jamb piece using 8d galvanized finishing nails to 2x4 or 2x6 structural frame members Alternate nailing from side to side nailing every 12 and approximately 3 4 from each edge Note If nailing product at 40 F or below pre drilling is required 4 Measure and cut Jamb side pieces to fit from top Jamb to floor nail as directed 5 Measure top Brick Mould to overlap the Jamb material by 2 This will allow for a 1 8 to 1 4 reveal around the Jamb Reveal should be on both top and sides Cut 45 angle on ends butt or angle joint middle seam if needed Note Reveal may vary depending on siding siding J channel brick or block installation 6 Install Brick Mould using 10d or 3 inch galvanized finishing nails spaced 12 on center Use PVC Cement in the mitered joint for optimum fit Note Nails should penetrate structural frame at least one inch 7 Measure and cut side Brick Mould trim to fit and install as directed Garage Door Thermo Stop 1 When installing Garage Door Thermo Stop alone open the garage door and remove old door stop with standard claw hammer 2 Close garage door Begin Garage Door Thermo Stop installation by measuring and marking 2
Download Pdf Manuals
Related Search