Phillips Manufacturing Company CBAVYL Instructions / Assembly
Contents
1. te HILLIP 9 Installation Recommendations MANUFACTURING CO Engineered to Perform C Sips gripSTIK Vinyl Max Flex Archway Installation Recommendations Phillips recommends installation in accordance with applicable ASTM standards and using prevalent industry standards General Installation Guidelines Phillips grip STIK vinyl Max Flex archway corner beads can be installed using a variety of methods The methods listed below are guidelines Phillips recommends Method 2 as it eases installation on curves and arches Some vinyl products require more detailed installation instructions than are listed here Method 1 Stapling 1 For regular not bullnose archway corner beads drywall does not need to be set back 2 For doors windows or special lengths cut the bead to length and dry fit a Prevent overlap of the mud flanges by snipping back b Dry fit the bead 3 Staple the solid mud flange every 6 10 with 1 2 crown staples Staple each flange segment on the notched mud flange with 1 2 crown staples 4 No primer is needed Finish as usual 5 For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 40 F or warmer Method 2 Spray Adhesive gripSTIK Spray Adhesive Recommended oh Follow steps 1 and 2 above 2 Put a coat of spray adhesive on the back of the bead and then on the drywall a Immediately apply bead to drywall and positio2. n in place b If the adhesive dries too long it will be hard to reposition c At some point the adhesive will lose tackiness and will not bond If this happens reapply adhesive to both surfaces 3 The rate at which the adhesive dries varies depending on heat and humidity Test in your conditions 4 Use handle of your taping knife or installation tool to apply pressure along both mud flanges Bond strength is greatly enhanced with this crucial step 5 Staple the solid mud flange every 6 10 with 1 2 crown staples Staple each flange segment on the notched mud flange with 1 2 crown staples Pressure the mud flanges again see step 4 No primer is needed Finish as usual For cold weather winter applications please refer to the installation recommendations in the Gypsum Association GA 220 06 of 50 F or warmer CO N OD With Phillips gripSTIK vinyl beads and trims No mud additives needed No primer needed Made in the U S A Phillips is proud that all our beads trims and accessories are made in the United States of America 2012 Phillips Manufacturing Company p Version 1 0 Page 1 of 1 PHILLIPSmrc com
Download Pdf Manuals
Related Search