Home
        none 5402 Installation Guide
         Contents
1. INSTALLATION INSTRUCTIONS is TSS  LADIES    ROOM 53 1 4   MEN   S ROOM 58 1 2   Clean Hands   Sanitary Door Openers are  recommended for all pull open  washroom  exit  doors  however  they should not be installed where  the backward swing of a door could contact an  unsuspecting person using a lavatory  towel dispenser  or other washroom equipment     6  MINIMUM    oc  Q  O       iL     O  a  L    1  Lightly mark a door for a Ladies    Restroom 53 1 4  inches from the floor and for a Men   s Restroom  58 1 2 inches from the floor  These marks are  for the top of the Openers  If needed  increase the  installation height for the Ladies    restroom slightly  to maintain a six inch minimum clearance  between the top of the conventional door handle  and the bottom of the Sanitary Door Opener  For  special situations  install the top of the Openers at  shoulder height     2  Insure that the screws provided are suitable for the  door thickness  If installation is on a metal or fire  rated door  through bolts  not provided  must be  used     3  Place Opener 1 4 inch back from the door edge  and mark the four hole locations  For metal doors   increase this set back so that bolt heads will not  interfere with the door    stop     ANGLE SLIGHTLY DOWNWARD    ANGLE SLIGHTLY    4  Prepare a 9 64 inch diameter drill bit for drilling pilot 9 64  UPWARD    holes for the screws  Place a drill stop on the bit or  place tape around it to indicate when the drill depth  is 1 4 inch less than the l
2. ength of the screws     5  Keeping a drill level  drill the two outside pilot  holes  Drill the top inside pilot hole slightly  downward  Drill the bottom inside pilot hole slightly  upward  DO NOT DRILL PAST EDGE OF TAPE     6  Install Opener on the door  END OF SIDE WITH  HOLES MUST FACE DOOR EDGE        SANITARY  7  Install the wall sign either on the wall adjacent to OPENER v    the Opener or on the door about one inch above Ii  the Opener  Press firmly over the entire sign to OPENER  achieve good adhesion   A reverse image of the    wall sign is not provided               8  REMOVE BURRS   VERY IMPORTANT  Using a hand file or powered abrasive point  yo  remove all burrs from the screw heads resulting OPENER  from the installation  Relocate existing door I Wo7  bumper or install new bumper  not provided  to  protect adjacent wall from Opener strikes        
    
Download Pdf Manuals
 
 
    
Related Search
    
Related Contents
Manual de usuario de Key Rig - M  Zalman HD503 computer case  HP Z440, Z640, and Z840 Workstation Series User Guide  Xerox® 4112™ y 4127™ Guía de seguridad  Modelo de exemplo de correio eletrônico    Copyright © All rights reserved. 
   Failed to retrieve file