Husky H4220 Instructions / Assembly
Contents
1. Operation 1 Operating the die grinder 2 Installing the mounted points This Die Grinder is designed to operate on 90 PSIG Lower pressure below 90 PSIG will reduce performance of the tool Higher air pressure over 90 PSIG raises the performance of the tool beyond its rated capacity and WARNING Disconnect the tool from the air supply before servicing or changing accessories Only use 1 4 ANSI standard mounted stones or carbide could cause serious damage to the tool and the user burrs rated at or above 20000 RPM Press the lever and push the safety bar to operate the tool Push the shaft of the stone or burr fully into the inside of the collet o Hold the die grinder spindle with the angle double ended spanner wrench B and tighten the collet nut with the double ended spanner wrench C Install the mounted point 3 Removing the mounted points 4 Grinding and deburring Connect the die grinder to the air supply WARNING Disconnect the tool from the air supply before servicing or changing accessories Hold the die grinder in one hand and start the rotation by operating the throttle lever Place the stone or burr on the work area and gradually apply pressure to achieve the desired amount of material Hold the die grinder spindle with the angle double ended hh spanner wrench B and loosen the collet nut with the doubl2. e ended spanner wrench C Remove the accessory from the die grinder
Download Pdf Manuals
Related Search