Three D Traffic Works 522027 Installation Guide
Contents
1. WS _ BOF AVG WORES Three D Innovative Traffic Safety Products INSTALLATION PROCEDURES BOOMERANG SURFACE MOUNT DELINEATORS TD5200 SERIES To assemble post and base 1 Mount post over riser on base and insert two 2 hex bolts 1 20 x 2 2 through the post Attach a Nyloc nut to each bolt and tighten to secure the post to the base Please note the following prior to installation 1 Posts that are to be mounted on the ground with adhesives require a clean surface prior to installation Make sure all dirt dust even fine dust rocks and or gravel have been cleared from the surface For best results after sweeping use compressed air to blow any fine particles from the surface If surface is wet it is always recommended to torch surface to remove moisture The bottom of the base should also be clean of any dust prior to installation When dealing with any sort of epoxy or bitumen use gloves at all times during mixing and installation When using epoxy Types A and B are to be mixed 50 50 prior to installation Bases manufactured by Three D Tratfic Works Inc do not require flame treating Units are to be spaced evenly according to specifications required by the instructions or manuals for each individual user contractor city state or federal agency To install unit assembled 1 Using epoxy Submerse bottom of base into pre mixed epoxy Do not fill inside cavity of base with epoxy only apply material to2. bottom ribs Turn once left turn once right to allow epoxy to ooze into holes in base and then remove from mixture Mount unit to prepped surface Using bitumen Kettle temperature for Bitumen varies and should be mixed according to the manufacturer s recommendation to assure the Bitumen stands up when poured This will allow the Bitumen to penetrate the holes on the TD5200 Base Place bitumen on cleaned surface and mount unit onto the bitumen Make slight turn once left then back right to remove air bubbles and allow bitumen to ooze into holes in base Do not fill inside cavity of base with bitumen Be sure to align base with arrows facing traffic Using Peel n Stick butyl pads Remove tape from one side of pad place on the road surface and apply pressure on top of pad Remove tape on top side once pad has been adhered to surface before mounting unit on the ground Align base with arrows facing traffic and push onto surface by applying pressure to the base to ensure bonding Apply firm pressure Too much pressure applied to base will cause the base to contact the surface directly and lessen the bond 430 North Varney Street Burbank CA 91502 877 843 9757 Fax 818 841 5096 www trafficwks com
Download Pdf Manuals
Related Search