Pleasant Hearth GFB100 Instructions / Assembly
Contents
1. Electrical Wiring Diagram AUTO OFF MAN 1 Power Cord 2 Bushing Strain Relief 3 Blower 4 Temperature Sensor O 5 Rocker Switch NOTE If any of the original wire as supplied with the appliance must be replaced it must be replaced with a wire of at least an equal temperature rating A CAUTION Label all wires prior to disconnection when servicing controls Wiring errors can cause improper and dangerous operation Verify proper operation after servicing MAINTENANCE OF MOTORS A WARNING Make sure all power to the appliance is turned OFF before proceeding Always disconnect the appliance from the main power supply and allow it to cool before any servicing operation The motor used on the flame blower is pre lubricated for extended bearing life and requires no further lubrication However periodic cleaning vacuuming of the appliance around the air intake and exhaust as well as the blower is recommended For heavy or continuous use periodic cleaning must be done more frequently If the heater blows alternating cold and warm air check the blower for free movement and for debris restricting air flow If the blower does not move freely the unit must be turned off and the blower replaced immediately in order to prevent further damage to the unit Troubleshooting PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Blower is not 1 There is no power to Verify blower is plugged in and spinning the blower o MAN or Blow2. appliance be modified Parts having to be removed for servicing must be replaced prior to operating this appliance again Do not use outdoors This heater is not intended for use in bathrooms laundry areas and similar indoor locations Never locate this appliance where it may fall into a bath tub or other water container Do not run cord under carpeting Do not cover cord with throw rugs run ners or the like Arrange cord away from traffic areas and where it will not be tripped over To disconnect this appliance turn controls to the off position then remove plug from outlet Connect to properly grounded outlets only This appliance when installed must be electrically grounded in accordance with local codes with the current USA installations or in the absence of lo cal codes the National Electric Code ANSI NFPA No 70 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock fire or damage the appliance To prevent possible fire do not block air intakes or exhaust in any manner Use this appliance only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons Installation and repair should be done by a qualified service person The appliance should be inspected before use and at least annually by a pro fessional service person More frequent cleaning may be required due to excessive
3. er is set to Allow 5 10 minutes for blower AUTO to engage Blower motor is bad Replace blower Blower is mak Blower housing or Clean blower and blower ing a loud noise blades are dirty housing Blower rotation is Verify wiring is not in blower blocked path Defective blower Replace blower Printed in China Warranty LIMITED WARRANTY This limited warranty is extended to the original retail purchaser of this product and warrants against any defect in materials and workmanship for a period of one 1 year from the date of retail sale GHP Group Inc at it s option will either provide replacement parts or replace or repair the unit when properly returned to the retailer where purchased or one of our service centers as directed by GHP Group Inc within one 1 year of retail purchase Shipping costs labor costs etc are the responsibility of the purchaser DUTIES OF THE OWNER This product must be operated in accordance with the written instructions furnished with this product This warranty shall not excuse the owner from properly maintaining this product in accordance with the written instructions furnished with this product A bill of sale canceled check or payment record must be kept to verify purchase date and establish warranty period Original carton should be kept in case of warranty return of unit WHAT IS NOT COVERED 1 Damage caused by misuse or use contrary to the owners manual a
4. he retailer is unable to resolve the problem contact our Customer Service Dept detailing the heater model the problem and proof of date of purchase 3 A representative will contact you DO NOT RETURN THE PRODUCT TO GHP GROUP INC unless instructed by our Representative This warranty gives you specific legal rights and you may also have other rights which vary from state to state TO REGISTER THE WARRANTY ON YOUR HEATER PLEASE FILL OUT THIS CARD COMPLETELY AND MAIL WITHIN 14 DAYS FROM DATE OF PURCHASE OR REGISTER ON LINE AT www ghpgroupinc com NAME PHONE EMAIL ADDRESS CITY STATE ZIP MODEL SERIAL DATE PURCHASED DEALER PURCHASED FROM TYPE OF STORE CITY amp STATE WHERE PURCHASED PRICE PAID Please Take a Minute To Give Us Your Answers To The Following Questions All Responses Are Used Solely For Market Research And Are Held In Strict Confidence Who primarily decided this purchase O Male LJ Female O 18 24 O 25 39 1140 59 CO 60 and over Purpose of Purchase Do you own any other portable heaters LJ Yes LJ No If yes type brand How do you intend to use your new heater 1 Construction Site J Farm L Warehouse Commercial L Garage Outbuilding LI Other How did you become aware of this heater LJ In Store Display LJ NewspaperAd LJMagazineAd O Friend Relative O TV Commercial O Store Salesperson O Other What made you select this heater O Style CO Size Portability 1 Price 1 Package O Brand UL Other Do you LJ own CO rent Wou
5. ld you recommend this heater to a friend LI Yes O No Please give us your comments THANK YOU FOR COMPLETING THIS FORM Information will be held confidential Pcie icy to Say SE EN an ey eae we ke ee EE E nd le pt ee eh ee ye ee ee re ee ies SA ee tei Se ee Le Pe ie y et ee de i ee Se eet ee el a ee 10 WARRANTY REGISTRATION IMPORTANT We urge you to fill out your warranty registration card within fourteen 14 days of date of purchase You can also register your warranty on the internet at www ghpgroupinc com Complete the entire serial number Retain this portion of the card for your records GHP Group Inc 6440 W Howard St Niles IL 60714 3302 Tel 877 447 4768 www ghpgroupinc com SAVE THIS CARD ee ea a am a aa ee eae a ee ae ta ee a a a eg ee a a Ngee ee eg a te a a a a a et ee ees a GHP Group Inc 6440 W Howard St Niles IL 60714 3302 ce ae en a E a a S a a a E a E E E a a E ae a a E E a a a a a a a E E a a a E E E ep a E ee a al 11
6. le ports on Temperature Sensor Insert the female plug on the white power supply wire marked with P1 into the corresponding male port marked with P1 Insert the female plug marked with P2 into the corresponding male port which is on the black power supply wire marked with P2 ASSEMBLY INSTRUCTIONS 9 10 11 12 Insert the blower link male plug into the power link female port Important Bind wires with cable ties G and attach cable ties G in holes on back of Outer Casing Attach one in hole near the top and one in hole near the bottom Insert AUTO OFF MAN wires through the Rocker Switch opening Connect AUTO OFF MAN wires to the three corresponding male ports on the Rocker Switch E Match the Auto wire to the symbol and the Man wire to the symbol on the rocker switch E ASSEMBLY INSTRUCTIONS 13 Push Rocker Switch E into Control Panel and secure 14 Check that all wires are secure and reattach Blower Access Panel to Outer Casing Capture the Green Ground wire between the Access Plate and Outer Casing with the upper right screw OPERATING INSTRUCTIONS Using Rocker Switch turn blower on and check for operation Turn on Rocker Switch to the desired position In the MAN position it will remain constantly on AUTO position will be controlled by the Temperature Sensor To stop the opera tion turn Rocker Switch to the OFF position
7. lint from carpeting bedding material etc It is imperative that control compartments burners and circulating air passageways of the ap pliance be kept clean PACKAGE CONTENTS Before beginning assembly of product make sure all parts are present Compare parts with package contents list and diagram under If any part is missing or dam aged do not attempt to assemble install or operate the product Contact custom er service for replacement parts at 1 877 447 4768 Parts List REF PART DESCRIPTION QUANTITY XB001 01 1 B _ XB002 010 Blower XB003 01 A Phillips head screwdriver is needed for installation ASSEMBLY INSTRUCTIONS CAUTION Firebox must be disconnected from gas supply and removed from mantel before installing fan accessory Contact a qualified service person to do this 1 4a 4b Remove Blower Access Panel Mount Blower B onto bottom of Fireplace Top using 4 screws F Attach Power Cord A to Blower Access Panel Attach Temperature Sensor C to Sensor Bracket using 2 screws 2 AN lock washers and 2 nuts Attach Sensor Bracket to the Combustion Top using 2 sheet metal screws Bracket Combustion Top Mounting Holes ASSEMBLY INSTRUCTIONS s Important Insert the wires marked with AUTO OFF and MAN into line slot on the right corner Keep wires close to the bottom Insert two wires female plugs marked with T1 and T2 black and yellow into two ma
8. nd safety guidelines 2 Damage caused by a lack of normal maintenance 3 Use of non standard parts or accessories 4 Damage caused in transit Freight charges on warranty parts or heaters to and from the factory shall be the responsibility of the owner This warranty does not imply or assume any responsibility for consequential damages that may result from the use misuse or the lack of routine maintenance of this heating appliance A cleaning fee and the cost of parts may be charged for appliance failures resulting from lack of maintenance This warranty does not cover claims which do not involve defective workmanship or materials FAILURE TO PERFORM GENERAL MAINTENANCE INCLUDING CLEANING WILL VOID THIS WARRANTY THIS LIMITED WARRANTY IS GIVEN TO THE PURCHASER IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY OF FITNESS FOR A PARTICULAR PURPOSE THE REMEDY PROVIDED IN THIS WARRANTY IS EXCLUSIVE AND IS GRANTED IN LIEU OF ALL OTHER REMEDIES IN NO EVENT WILL GHP GROUP INC BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES Some states do not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you CLAIMS HANDLED AS FOLLOWS 1 Contact your retailer and explain the problem 2 Ift
9. replace System Blower MODEL GFB100 Compatible Fireplace Systems VFF PH20D VFF PH26D VFF PH32DR IMPORTANT INSTRUCTIONS PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE WARNING IF THE INFORMATION IN THIS MANUAL IS NOT FOL LOWED EXACTLY A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE PERSONAL INJURY OR LOSS OF LIFE WARNING THIS PRODUCT IS ONLY FOR USE WITH MODELS SPECI FIED IN THIS MANUAL BY THE MANFACTURER ANY OTHER USAGE OR INSTALLATION NOT SPECIFIED IN THIS MANUAL IS PROHIBITED Questions problems missing parts Before returning to your retail er call our customer service department at 1 877 447 4768 8 30 a m INSTALLER Leave this manual with the appliance CONSUMER Retain this manual for future reference m 4 30 p m CST Monday Friday or email us at customerservice ghpgroupinc com 80 10 101 REV 2013 05 10 SAFETY INFORMATION SAVE THESE INSTRUCTIONS Awarnine This appliance is equipped with a three prong grounding plug for your protection against shock hazard and must be plugged directly into a properly grounded three prong receptacle 1 2 3 11 12 13 14 Read all instructions before using this appliance If possible always unplug this appliance when not in use Do not operate any heater with a damaged cord or plug or after the appli ance malfunctions has been dropped or damaged in any manner Under no circumstances should this
Download Pdf Manuals
Related Search