Speakman S-1495-AF Instructions / Assembly
Contents
1. 7 2747 01 12 Visit us on the web at www speakmancompany com S 1495 AF IOMR2 MAINTENANCE The Regency valve relies on ceramic components quad rings and O rings for sealing There are no seat washers or packings to repair which reduces the need for routine maintenance The valve contains two easily replaceable modules They are the balancing module and the regulating module After shutting off the water supplies to the valve simply remove the trim and unscrew the valve bonnet When replacing the balance module make sure that the quad ring seals are properly installed within the module and that the module is installed with the seals directly over the body inlet ports The gleaming finish of your SPEAKMAN Regency shower can be cleaned by using mild soap and warm water Dry immediately with a soft clean cloth for best results ROUGH IN MEASUREMENTS 7 4 o 178mm A i PIPE STRAP NOTES 1 ALL DIMENSIONS ARE IN INCHES MILLIMETERS AND SUBJECT TO CHANGE WITHOUT NOTICE 2 UNIT CAN BE INSTALLED WITH CEILING FLOOR OR THROUGH THE WALL SUPPLIES 3 3 Y2 NPT FEMALE INLETS MAINTENANCE U PART NUMBER DESCRIPTION NOT cc r G05 0412 MO CERAMIC REGULATING MODULE ASSY NOT SHOWN G05 0413 BALANCING MODULE ASSY W QUAD RINGS i ae RPGO4 0367 HANDLE WITH SCREW SPEAKMAN 400 Anchor Mill Rd New Castle DE 19720 Phone 800 537 2107 Fax 800 977 2747 01 12 Visit us on the web at www speakmancompany c2. SPEAKMAN S 1495 AF Installation Maintenance amp Operation Instructions SENTINEL MARK II REGENCY SHOWER DESCRIPTION Speakman Sentinel Mark Il Regency exposed anti scald balanced pressure shower Brass lever handle Adjustable temperature limit stop Chrome plated cast brass body Pressure balancing module Ceramic temperature regulating module 2 NPTF inlets and outlets Adjustable stops for supply connections from floor ceiling or wall 7 1 2 center to center Polished chrome plated brass gooseneck with supporting strap S 2292 AF showerhead with flow control device reduces flow to 2 5 GPM 9 46 LPM maximum to meet existing ANSI A112 18 1M Standard Vandal resistant standard Meets ASSE 1016 1989 Standard SPECIFICATIONS SUPPLY 2 NPT FEMALE FLOW RATE SHOWERHEAD 2 5 GPM 9 46 LPM FIXED SHIPPING WEIGHT 7 5 LBS STATIC PRESSURE 20 80 PSI OPTIONS rey 2 S 2252 ANYSTREAM 3 9 2253 ANYSTREAM e 4 S 2288 pen renee SHOWERHEAD SHOWERHEAD SHOWERHEAD INSTALLATION Note Refer to the rough in during installation Install the hot and cold supply lines for the valve either through the wall from the ceiling or from the floor For ceiling and floor supply installations hold 1 from finished wall to center of supply lines Supply inlets are 2 NPT female Apply pipe sealant to male threaded supply lines Slip strap on to gooseneck Apply sealant to inlet threads of gooseneck and screw into valve body Tighte
3. n and position outlet with valve body Connect valve body assembly to the supply lines Fasten support strap to finish wall screws 2 supplied Location is optional Apply pipe sealant to gooseneck outlet threads and attach showerhead Open supply lines and check all connections for leaks To adjust the temperature limit stop remove the handle and dial cap from the valve Remove the rubber retaining ring and the first temperature limit stop TLS plate The second TLS plate should be adjusted so that it comes into contact with the lower side of the bonnet post when the valve is in the OFF position Now turn the valve on to the desired maximum hot water discharge temperature assemble the first TLS plate so that it contacts the upper side of the bonnet post Turn valve off and reassemble the retaining ring cap and handle Because of fluctuations in the hot and cold water temperatures it is not recommended that the temperature limit stop be used to preset the unit for showering temperatures Back to Back Installation On this type of installation the regulating disc must be rotated 180 on the valve on which the hot and cold inlets are reversed OPERATION Note Both the hot and cold water supplies must be on for the valve to operate properly The handle of the valve is rotated clockwise to the desired temperature and then counter clockwise to turn the valve off SPEAKMAN 400 Anchor Mill Rd New Castle DE 19720 Phone 800 537 2107 Fax 800 97
4. om S 1495 AF IOMR2
Download Pdf Manuals
Related Search