Pegasus 2-413SN Installation Guide
Contents
1. Victoria High Tank Cat No The Victoria High Tank Toilet is shipped in 3 cartons Carton A 2 802 Toilet bowl with spud installed 2 x 1 1 4 Carton B 1 2 412 Toilet tank and cover with trim bag which includes Carton C HTT Trim Kit for High Tank Toilet includes Toilet A BARCLAY INSTALLATION INSTRUCTIONS float valve float ball float rod flush valve and rubber flapper e White Plastic Nut 5568 e Flush Pipe 1 1 4 x 72 5569 e Straight Supply Pipe 1 2 OD x 72 5552 e Slip Nut 1 1 2 x 1 1 4 Side View 5567 e Wall Bracket 1 1 4 with 2 Brass Screws 5570 e Flush Elbow Assembly with 2 Slip Nuts amp Washers 5560 e Spud Reducer 2 x 1 1 2 with Rubber Washer 412 HA e Tank Handle Assembly Tools Needed e Hacksaw or Tube Cutter Phillips Screwdriver Level 1 4 Drill Bit e Wrench e e Wax Ring Seal or Plumbers Putty Large Screws or Toggle Bolts e Be sure to re inforce wall before installation We recommend a 2 x12 securely fastened to 8 9 wall studs at desired height for your installation Shut off water supply disconnect plumbing and remove existing toilet bowl Install 412 HA tank handle assembly with chain to tank Remove handle screw with Phillips screwdriver and remove handle Using new wax ring seal or plumbers putty neither are furnished mount the toilet bowl to the floor drain opening To attach the tank to th2. e wall locate and drill holes through 2 x12 re inforced wall approximately 80 above the floor The holes should be 8 center to center You may choose any height between 75 and 82 amp later trim the flush pipe assembly Use proper hardware to attach the tank to the wall Large screws toggle bolts or other fasteners can be used depending on the wall material A small spacer should be placed between the wall and the tank to allow the tank lid to fit flush with the front of the tank These parts are NOT furnished Attach tank to wall and use level to ensure that tank is level Slide the 5552 slip nut up 5568 flush pipe and connect the slip nut to the 5560 spud reducer outlet at the bottom of the tank Do not forget the washers Loosen the two brass screws on the 5567 wall bracket Slide bracket onto flush pipe position bracket at height where the lip of the toilet seat cover will come in contact with the bracket Tighten the two brass screws to secure position Fasten flange to wall Insert 5570 flush elbow well into the toilet bowl taking care to use rubber washers and slip nuts Do not damage washer or strip nut Note The brass angle stop valve amp flange are NOT included Insert 5569 supply pipe into tank and tighten carefully using white plastic nut Install toilet seat not furnished 7 27 10 P 8472441234 www barclayproducts com
Download Pdf Manuals
Related Search