MUSTEE 300.600WBN Instructions / Assembly
Contents
1. 300 706 Caulking Items Not Shown E L MUSTEE amp SONS INC 494 Alant 4 Ath Ceront a Mlovwoland Dhin 4A74 SI 146 8 082. Panels to fit Follow the same cleaning and bonding procedures as outlined for Sill panel 4 Follow the same procedure for installing the remaining right side panel BE SURE to remeasure the right side do not assume that the dimensions are the same for both left and right sides 5 Caulk seams where side panels overlap sill panel use smallest bead possible SI 146 8 98 MUSTEE MODEL 300 600W 6 Apply adhesive to underside of Corner Moulding position in either corner and press in place Follow same procedure for remaining Corner Moulding 7 Do not use abrasive cleansers to clean window kit use liquid or spray cleaners such as Clorox Tub n Tile Cleaner 409 or Soft Serub A periodic coating of a quality silicone wax will retain the fine gloss finish of your Window Trim Kit as well as your tub surround SPECIAL NOTICE After cleaning excess adhesive with the proper material as specified by adhesive manufacturer IMMEDIATELY WASH UNIT COMPLETELY WITH A SOAP WATER SOLUTION This will neutralize any continuing chemical reaction between the solvent and window kit material FAILURE TO WASH AWAY SOLVENT MAY CAUSE BLEACHING OR LOSS OF COLOR IN WINDOW KIT MATERIAL PARTS ILLUSTRATION PART NUMBER WHITE BONE KEY DESCRIPTION 1 300 605 300 606 Corner Moulding 2 Req d 2 300 604 300 603 Formed Panel 3 Req d 3 36 704 36 704 Adhesive Cartridge 4 300 721
3. MUSTEE MODEL 300 600W DURATRIM DURATRIM FIBERGLASS INSTALLATION OPTIONS THIS INS TALLATION TOP EDGE OF 9 PRODUCES 2 TAPER APPROX TUB SURROUND CUT FROM FORMED PANEL THIS INSTALLATION PRODUCES 4 TAPER APPAOX LLLLETES peppy RSA AML LLLLP LIL IIIF FILL IN DIMENSIONS FOR FUTURE REFERENCE DOUBLE CHECK ALL MEASUREMENTS BEFORE CUTTING PANELS OR CORNER MOULDINGS Designed for Mustee Bathtub Wall or any other wall surround Fits bathtub alcove windows up to 36 wide x 8 deep Kit material can be easily trimmed with simple hand toois Universal Formed Panel may be used for either Side or SHI EASY TO INSTALL 1 Remove original window casing moulding sill or stool that protrude into bath alcove area Measure width and depth of sill and both side jambs at least to top edge of tub surround 2 Cut one of the Formed Panels to be used as the Sill be sure to leave approximately 1 16 clearance for thermal expansion on width dimension Be sure bonding surface is clean it is a good practice to tack surface before applying adhesive Apply adhesive directly to surface spread with notched trowel press pre cut Sill panel in place 3 Measure height of left side of window opening from surface of sill to top edge of tub surround recommended measure depth at surface of sill and also at top edge of tub surround Cut one of the Formed
Download Pdf Manuals
Related Search