none X-RC6776 Instructions / Assembly
Contents
1. a wire nut c The Motor blue wire to the blue For Light wire from Receiver with a wire nut d The white wire from Outlet Box to the red AC in N wire from Receiver with a wire nut e The black wire from Outlet Box to the red AC in L wire from Receiver with a wire nut Make sure all of wire nuts are connected firmly Tuck all wire nuts and wires carefully up into the Outlet Box EXCEPT antenna which should remain outside Outlet Box Antenna Leave unconnected _ Antenna and do not cut DO NOT CUT S37 OR SPLICE Hanger Bracket VIEW AFTER INSTALLATION 5 Install a 9V battery not included into the transmitter Turn on the power press button of transmitter to operate the fan See Fig 5 6 Functions of Transmitter See Fig 6 Note HI Turn on the fan at high speed This remote controller has memory function MED Turn on the fan at medium speed setting The fan will operate at the same speed and the fan light will stay at the same LOW Turn on the fan at low speed status as the last time the power supply was FAN OFF Turn off the fan turned off LIGHT ON OFF Press and release immediately to turn on or off the light 7 Install the transmitter wall bracket in wall by two screws and hang transmitter in it carefully See Fig 7 TO INSTALL THE BATTERY PRESS DOWN AND SLIDE OUT BATTERY HOUSING COVER Transmitter Wall Bracket Battery Housing Page 22. REMOTE CONTROLLER INSTALLATION INSTRUCTION IMPORTANT NOTE 1 You must set ceiling fan manual switch to high speed and light kit if any to on position before operating remote control 2 Read and save these instructions 3 Please note that all fixed wiring appliances should be installed by a qualified electrician 4 The supply to the remote control receiver should be connected through a mains switch i e existing wall switch 5 Before installing Remote Controller make sure the Main Power Supply is turned off 6 Install receiver into the ceiling fan canopy of the fan to ensure proper protection 7 Electric Rating AC120V Light 300W Max Fan 1 25A Max 8 Do not install in damp locations or immerse into water For indoor use only 9 Do not install in Tungsten Light kit only for the Energy saving bulb 10 Do not pull on or cut leads shorter 11 Do not drop or bump the unit 12 The Battery will weaken with age and should be replaced before leaking takes place as this will damage the transmitter Dispose of used battery properly Keep the battery out of reach of children 13 CAUTION To reduce the risk of fire or injury do not use this product in conjunction with any variable rheostat wall control SET CODE SWITCH BETWEEN TRANSMITTER AND RECEIVER There is a code switch in transmitter and receiver See Fig 1 First Set all of the 4 keys at ON position If more than one remote controlled fan is
3. installed or the code interfered the fan may function abnormally In this situation you need to reset the fan code switch as per following instructions Please use a ball pen or any convenient tool to poke keys to select a desired code mode which will not interfere with other electrical units There ON DAR ON position are 15 code modes for selection excluding the Key a A a A OFF position 2 original ex factory mode See Fig 2 3 Fig 1 CODE SWITCH we Ex Factory Mode Please note to change the code switches in the transmitter amp receiver at the same time amp at the same key position When 1 key is in OFF position When 2 keys are in OFF position When 3 keys are in OFF position When 4 keys are in ON or OFF position Page 1 INSTALL AND MAKE WIRE CONNECTION 1 Make sure the electric power was turned off 2 Ceiling fan must be set at HIGH speed and light kit if any at ON position by pulling the Pull Switch after installation 3 Once the connection has been made the receiver inserts into the drop rod hanging bracket The canopy comes up to cover the receiver and bracket See Fig 3 4 Make Wire Connection See Fig 4 a The Motor white wire to the white To Motor N wire from Receiver with a wire nut b The Motor black wire to the black To Motor L wire from Receiver with
Download Pdf Manuals
Related Search