Smart Solar 3141WRM4 Use and Care Manual
Contents
1. Introduction Solar lights work by using electricity generated from the sun by the solar panel to charge internal batteries These batteries are then used to power the light When switched on the lights automatically illuminate at night by using a light sensor The duration of illumination will depend on the amount of sunlight and therefore charge received by the batteries Contents Required parts Not Included 8x screws Position A Pe g 1 ie Tk g T 7 m m n a ily Do not position too near a light as this will Position to receive the prevent the light from switching on at night maximum amount of sunlight First Use Although there may be some initial charge in the battery we recommend fully charging each light before first use Leave the switch in the off position for at least 1 sunny day to ensure the battery is fully charged Once fully charged switch on and the light will automatically illuminate when it gets dark You can cover the solar panel to test that the light will operate Battery Rechargeable batteries become less efficient with repeated charge discharge cycles and the battery capacity reduces If you find that the battery appears to be less efficient or does not run for long we suggest you first try to boost charge it Switch off for 3 to 5 sunny days to allow the maximum charge to the battery If after this boost charge your batter2. y still does not perform to expectations you should replace it All our batteries are covered by a 1 year warranty To change the battery open the battery compartment on the underside of the small owl or back of the large owl Remove the 6 screws as shown and lift off the cover and inner rubber gasket Remove the existing battery and replace with a new one Replace the gasket cover and screws Only use Ni MH rechargeable batteries Please ensure that the battery is disposed of according to local regulations Installation Step 1 Drill two level holes a 2 3 16 apart into the desired mounting surface Step 2 Insert wall plugs b into the holes Step 3 Fit the screws c into the wall plugs b Ensure 0 5 of the screw is left protruding from the mounting surface Position the holes 1 onto the protruding screws Slide the Wall light downwards to lock the screws into position 2 2 3 16 58mm T Clean the panel using water or glass cleaner Do not use an abrasive sponge on panel surface Customer Service For immediate answers visit our website www smartsolar com where you will find extensive trouble shooting FAQs and support Alternatively contact us using the details below Email ussupport smartsolar com Tel 1 813 343 5775
Download Pdf Manuals
Related Search