Home Decorators Collection 8188010280 Installation Guide
Contents
1. HOME DECORATORS COLLECTION Hardwire Pendant Light Assembly Instructions HDC 8188010280 MFG PBW 3568 5880 Please read over the instructions it will be a time saver in the long run PACKAGE CONTENTS Description Quantity Crossbar Mounting Screw Wire Nut Finial Nut Canopy Compression Nut Glass shade Lamp cup Decorative ring Socket Ring Bulb not included IMPORTANT SAFETY INFORM ATION TURN POWER OFF AT THE MAIN POWER PANEL OR FUSE BOX BEFORE INSTALLING OR REPLACING THE FIXTURE AND OR WHEN REPLACING THE BULBS THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED If you are not familiar with electrical wiring it is recommended that you secure the services of a qualified electrician show can assure that this installation meets local state and national codes The electrical system and the method of connecting this fixture to the system must be in accordance with local state and national electrical codes This fixture is to be connected to a 120 volt 6 0HZ power source Connecting to a different power source may create a hazard and will void the warranty Do not use near or around flammable combustible materials or liquids The bulb and unit can get hot during use Turn off the power and allow the unit to cool down for at lea2. st 20 minutes before working on the unit Never use a bulb with a higher wattage than the stated maximum wattage allowed for the fixture Using a higher wattage bulb may cause a fire hazard and or cause damage to the unit If it becomes necessary to replace the glass only use a tempered safety glass of equal thickness Do not attempt to open the fixture housing There are no serviceable parts inside All fixtures should be mounted to a ground junction box CEILING INSTALLATION Pull out all wires White Black and Ground out of junction box Unscrew Compression Nut F from Canopy E and slide Canopy E down cord Then unscrew Finial Nut D from the Crossbar A and slide the Crossbar A to suitable place to ease installation of Crossbar A to junction box Mount the Crossbar A to the junction box by using provided Mounting Screws B as shown in the picture Using Wire Nuts C connect black wire from fixture to black wire from junction box Connect white wire from fixture to white wire from junction box Connect green wire of fixture to green or copper ground wire from the junction box NOTE Some junction boxes may not havea ground wire Inthis case attach green wire from the fixture to the ground screw located on Crossbar A as shown in the picture Tuck wires back into junction box Screw Finial Nut D onto Crossbar Slide Canopy E back up cord and against the ceiling then use Compression Nut F to fi
3. x the Canopy E pls don t over tighten the Compression Nut F Attach Shade G to the Lamp Cup H through decorative ring I and then screw on the socket ring J colckwise until tight Install bulb not included WARNING For some length adjustments it may be necessary to cut the cord For this turn off all power at the main powr panel or fuse box then call a qualified electrician who can assure thatthis modeifcation meets all safety and local regulations
Download Pdf Manuals
Related Search