Aspects SWF213SCT Installation Guide
Contents
1. screws provided B Pull the wires tight and cut cord allowing for 6 inches of wire for junction box wiring Carefully remove outer insulation from cord without damaging lead wires Strip lead wires back 3 8 inch for wire nut connections WARNING Inspect modified cord and wires for any damaged insulation C Install four decorative bars 6 to canopy by securing them with short screws and ball nuts 7 Note turning the assembly up side down may make threading the a fy Cae Assembly Instructions 1 Preparing for installation e 8 4 D screws easier 2 Wiring All wiring must take place inside junction box Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of ballast use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A Feed cord through center hole in mounting plate 2 B Securely attach green wire to ground supply wire and ground screw located in mounting plate C Using wire connectors provided connect white supply wire to white fixture lead ee ae Connect black hot supply wire to black fixture lead Do not mix wires Pull on oy as each wire lead to make sure connections are secure Make sure no bare wires are i exposed outside of wire connectors 3 Fixture mounting A Install fixture threaded end t2. SWE213 Fluorescent Semiflush Fixture Models SWE213 Safety Precautions Read all safety precautions and installation instructions carefully Make sure that the power source conforms to the requirements of the before installing or servicing this fixture Failure to comply with fixture See labels on fixture Not for use with dimming circuit these instructions could result in potentially fatal electric shock and or property damage To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper It is recommended that all wiring be performed by a qualified grounding there must be a separate ground wire green or bare metal electrician This fixture must be wired in accordance with all national contact metal conduit between this fixture and the ground and local electrical codes connection of your main power supply panel The green ground screw location is clearly marked on the fixture housing Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a wet or damp surface or This fixture is intended for use as general indoor lighting in dry or in water damp locations only Disconnect electrical power before installing or servicing any part of this fixture A Install canopy mounting screws 2 through center screw holes Attach mounting plate 1 to junction box not provided in position shown with 8 32 x 1 1 2
3. hrough the canopy central hole and secure it with plate 4 and nut 3 Lamping A Install two 13 watt self ballasted compact fluorescent spiral lamps 8 into socket by inserting pins into holder and twist until it snaps in place CAUTION RISK OF FIRE Max 13 watt type GU 24 provided TCP 33113SP or Maxlite MLSI3GUWW recommended for replacements only 5 Diffuser mounting A Install glass diffuser 9 over threaded rod and secure with and plastic plate 10 iron plate 11 and nut 12 B Install cap 13 over threaded rod and secure it with the knob 14 6 Power to the fixture can now be restored Limited Factory Warranty American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit Page 1 of 1 8060613 R1 American Fluorescent UL us design efficiency technology
Download Pdf Manuals
Related Search