Aspects SWP313SCT Installation Guide
Contents
1. 1 to junction box not provided in position shown with 8 32 x 1 1 2 screws SS provided not shown 3 B Determine desired stem length for fixture Note one 4 stem 7 one 8 stem not o o 4 shown and three 12 stems 6 are included with fixture C Thread top stem into lower stem Note Each length has a threaded nipple in one end to 5 connect it to the next part Itis best to slide the wires through each individual stem before connecting them Once stems are at connected to desired length attach canopy 3 to stems by screwing them into the hang straight 5 D Pull the wires tight and cut cord allowing for 6 inches of wire for junction box wiring Carefully remove outer insulation from cord without damaging lead wires Strip lead wires back 3 8 inch for wire nut connections WARNING Inspect modified cord and wires for any damaged insulation 2 Wiring All wiring must take place inside junction box Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of ballast use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing 00 A Feed cord through center hole in mounting plate 1 B Securely attach green wire to ground supply wire and ground screw located in mounting plate C Using wire connectors pro2. SWP1 13 Fluorescent Pendant Fixture Models SWP113 Safety Precautions Read all safety precautions and installation instructions carefully Make sure that the power source conforms to the requirements of the before installing or servicing this fixture Failure to comply with fixture See labels on fixture Not for use with dimming circuit these instructions could result in potentially fatal electric shock and or property damage To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper It is recommended that all wiring be performed by a qualified grounding there must be a separate ground wire green or bare metal electrician This fixture must be wired in accordance with all national contact metal conduit between this fixture and the ground and local electrical codes connection of your main power supply panel The green ground screw location is clearly marked on the fixture housing Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a wet or damp surface or This fixture is intended for use as general indoor lighting in dry or in water damp locations only Assembly Instructions 1 Preparing for installation D Disconnect electrical power before installing or servicing any part of this fixture HA A Install 1 1 8 canopy mounting studs 2 through center screw holes Attach mounting 2 plate
3. vided connect white supply wire to white fixture lead Connect black hot supply wire to black fixture lead Do not mix wires Pull on each wire lead to make sure connections are secure Make sure no bare wires are exposed outside i of wire connectors 3 Fixture mounting A Press canopy 3 over mounting studs 2 and fasten with thumbnuts 4 4 Diffuser mounting A Install glass diffuser 9 over threaded socket 8 and secure with screw collar 10 5 Lamping A Install 13 watt self ballasted compact fluorescent spiral lamp 11 into socket by inserting pins into holder and twist clockwise until it locks in place CAUTION RISK OF FIRE Max 13 watt type GU 24 lamp provided TCP model 33113SP or Maxlite model MLS13GUWW recommended for replacement only 6 Power to the fixture can now be restored Limited Factory Warranty American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit OG Page 1 of 1 American 8060615 R2 Fluorescent UL us design efficiency technology
Download Pdf Manuals
Related Search