Sea Gull Lighting 41115-962 Installation Guide
Contents
1. For Fixture Reference ITEM INSTALLATION STEP 1 Punch out appropriate holes in backplate A if applicable to corre spond with holes in outlet box STEP 2 Push socket wires thru plastic bushing If applicable HC 844 STEP 3 A Take note of the color of the wire s on your fixture Identify which group your fixture wire s falls into and connect the wires according to the directions below GROUP A CONNECT TO BLACK GROUP B CONNECT TO WHITE HOUSE WIRE HOUSE WIRE BLACK WHITE Cc A B Take your fixture wire s from group A and place evenly against the black wire from the outlet box Do Not twist wires together before using wire connectors C Fit a wire connector not supplied over the wires and screw the connector clockwise until you feel a firmness D Try gently to pull the connector off the wires If you can pull the connector off carefully re do steps B and C as above and check again for a firm connection E Connect the fixture wire from group B to the white wire from the outlet box in the same manner GROUNDING INSTRUCTIONS Wrap the ground wire from the fix ture if supplied and the ground wire from the outlet box bare metal or green insulated wire around the green grounding screw on the back plate A Or if applicable The green grounding screw is to be inserted into the hole with two raised dimples provided on the back plate A NOTE Underwriters Laboratories U L does n2. INSTALLATION AND SAFETY INSTRUCTIONS FIGURE 1 NOT SUPPLIED BACKPLATE A OUTLET BOX arene OUTLET BOX GROUND SCREWS WIRE FOR YOUR SAFETY WARNING BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF GENERAL You don t need special tools to install this fixture Be sure to follow the steps in the order given Read instructions carefully If you are unclear as to how to proceed consult a qualified electrician NOTE Proper wiring is essential for the safe operation of this fixture ASSEMBLY Carefully remove the fixture from the carton and check that all parts are included as shown in Figure 1 2 amp 3 Be careful not to misplace any of the screws or parts which are needed to install this fixture STEP 1 Remove glass support brace D from backplate A STEP 2 Install glass through support brace D NOTE FOR FIXTURES PROVIDED WITH 75 C OR 90 C SUP PLY WIRE WARNING ONLY THESE WARNINGS ARE PROVID ED ON THE U L LABEL AND ON THE FIXTURE CARTON RISK OF FIRE MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C CONSULT A QUALIFIED ELECTRI CIAN BEFORE INSTALLING GLASS SUPPORT BRACE D GLASS E FIGURE 2 NUTS R GLASS x SUPPORT BRACE D FIGURE 3 Sd gull lighting Installation And Safety Instruction HC 844 022205 Fill In Item Number On Carton And File This Sheet
3. ot require all fixtures to have ground wires These fixtures still meet all U L specifications The listing mark of Underwriters on the product identifies products manu factured under its listing and Follow Up Service Programs NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES FINAL ASSEMBLY Make sure no bare wires can be seen outside wire connectors STEP 1 Tuck wires into outlet box Attach backplate A to outlet box by placing outlet box screws not supplied through punched out holes in backplate A STEP 2 Install lamp STEP 3 Secure support brace D and glass E to backplate with cap nuts R CLEANING To clean wipe fixture with a soft cloth Clean glass with a mild soap Do not use abrasive materials such as scouring pads or powders steel wool or abrasive paper ORDERING PARTS Keep this sheet for future reference and in case you need to order replacement parts All parts for this fixture can be ordered from place of purchase Be sure to use exact wording from illustration when ordering parts
Download Pdf Manuals
Related Search