Home
the great outdoors by Minka Lavery 8264-66-L Instructions / Assembly
Contents
1. E Fig 2 FIXTURE WIRES BLACK FIXTURE WIRES GREEN OR BARE R L COPPER GROUND BARE COPPER GROUND A P Female Jacket pm Aluminum Pane Ll Q Graphite Sheet O Male oo T J LED Wodule N Glass M Module Ring K Module Screws Gr Notice lt is important to use proper chain pliers not included To OPEN and CLOSE the chain included with this fixture Do not open them with other tools that may twist or stress the chain links It is important to use proper chain pliers like the ones shown in the diagram
2. INSTALLATION INSTRUCTIONS Model 8264 L READ AND SAVE THESE INSTRUCTIONS WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR PREPARING FOR INSTALLATION Fig 1 1 Shut of the power at the circuit breaker and remove the old fixture including the mounting hardware 2 Thread nipple L into loop F until snug 3 Thread other end of nipple L into the cross bar B until snug and secure with lock washer and hex nut Note the length of nipple L into cross bar B may be adjusted 4 Attach the cross bar assembly to the ceiling outlet box with screws C the side of the crossbar marked GND must face out Tighten screws securely with screwdriver HANGING THE FIXTURE Fig 1 5 Determine the desired hanging height and remove the excess chain with proper chain pliers to avoid damaging the finish 6 Open one end of the chain and connect it to the fixture chain loop I and close the link Thread the wire carefully through the chain links 7 Place lock ring G followed by canopy E over the chain and allow them to carefully rest on the fixture body 8 Open the other end of the chain and attach it to chain loop F and close the link 9 Feed the wires through loop F and nipple L CONNECTING THE WIRES Fig 2 10 Connect the electrical wires as shown in Fig 2 making sure that all wire connectors are secured If your outlet has a ground wire gr
3. een or bare copper connect the fixture s ground wire to it Otherwise connect the fixture s ground wire directly to the crossbar using the green screw provided Tuck the wire connections neatly into the junction box FINISHING THE INSTALLATION Fig 1 11 Raise the canopy E to the ceiling and secure with lock ring G 12 Bulb J information 1 x AC LED 10W included DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE Replacing LED module Fig 3 The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached See installation steps for more details Fig 3 a Shut off power and unplug the male and female jacket O amp P b Loosen module screws K and carefully remove LED module J for re lamping Note The LED module should be provided by a specified supplier c For better heat dissipation the LED module J should be installed with the heat transfer material Q when re lamping Your installation is now complete Return power to the junction box and test the fixture Note Illustration Fig 1 on this manual is for installation purposes only It may or may not be identical to the fixture purchased P american ooe bed K TE lighting association Intertek Set Cross Bar Ground Screw 1 Mounting Screws 2
Download Pdf Manuals
Related Search
Related Contents
EF24-105mm f/4L IS USM Sea Gull Lighting 65146-814 Installation Guide arrocera multiuso de 24 tazas 24-cup multi-use rice attix 3 attix 5 attix 7 attix 12 gallon attix 19 gallon Tecumseh AJE2433ZXA Performance Data Sheet Black & Decker 2701 Instruction Manual U M Nv M 5. PHOTOstudio Rapport final 2013-2015 AD1000 Copyright © All rights reserved.
Failed to retrieve file