Aspects TPDW213RBPLT Installation Guide
Contents
1. Adjust the correct fixture aiming angle position by rotating it upward or downward 6 Restore power at fuse or circuit breaker box Limited Factory Warranty American Fluorescent Corporation warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit 1 of 1 8060713 R1 American Fluorescent Y design efficiency technology LISTED2. Wiring all wiring must take place inside junction box not included Caution Make sure power is off at fuse or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of the ballast power supply use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing A Secure fixture arm 8 on the junction box threaded cover not included with locknut 7 included B Make all wire connections to appropriate wire Secure with wire nuts included C Connect the green wire from the fixture to the power source green wire D The black wire from the fixture is connected to the black wire from power source E The white wire from the fixture is connected to the white neutral wire from power source F Tuck all connections neatly into junction box 3 Lamp Install appropriate lamps included per label Insert lamps 3 into lamp holder 10 and push in until lamp snaps in place NOT INCLUDED CA E f y i a N a f B 4 Lens Install the front lens by engaging Y A a Se WZ A i the hooks 12 with the mounting slots 11 and align the captive screws 1 on the lens 2 with the holes 4 on the top of the housing 5 Secure lens and frame 2 with the two screws 1 5 Positioning Fixture with the Swivel Arm Assembly A Loosen the bolt 9 on the swivel arm assembly base
3. Outdoor Wall Pack Fluorescent Floodlight Model 324554 TPDW213RBPLT 120VAC 60Hz Safety Precautions This fixture is designed for use in a 110 120VAC 60Hz fused circuit Read all safety precautions and installation instructions carefully Do not use on a dimming circuit before installing or servicing this fixture Failure to comply with these instructions could result in potentially fatal electric shock and or To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper property damage l D _ a l grounding there must be a separate ground wire green contact fixture must be wired in accordance with all national and local supply panel electrical codes na ae ee l l l l This fixture is intended to be used for general outdoor lighting in wet Do not handle any energized fixture or attempt to energize any fixture locations with wet hands or while standing on a wet or damp surface or in water ASSEMBLY INSTRUCTIONS 1 Preparing for installation A Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture B Carefully remove the fixture from the carton and unscrew the lens screws 1 to remove the lamps inside the housing 5 Make sure to check that all parts are included as shown in figure below Be careful not to misplace any of the screws or parts which are needed for installing the fixture 2
Download Pdf Manuals
Related Search