Minka Lavery 3122-301 Installation Guide
Contents
1. INSTALLATION INSTRUCTION FOR FIXTURE 3122 301 WARNING SHUT OFF THE POWER AT FUSE OR CIRCUIT BREAKER ASSEMBLY THE FIXTURE FIG 2 Fig 2 1 Carefully unpack your new fixture and lay out all the parts on for installation 2 Thread the Loop A onto the Nipple B tightly 3 Slide the candle cover D over the socket C then install the light bulb in accordance with fixture s specifications DO NOT EXCEED THE MAXMUM WATTAGE RATING LOOP A a clear area Take care not to lose any small parts necessary ae BULB CANDLE sae ON HUW CaN ve ag x g 4 MOUNTING THE FIXTURE FIG 1 1 Shut off the power supply at the fuse box or circuit breaker box Remove the old fixture from ceiling Including the cross bar 2 Thread the nipple into the collar loop J until snug 3 Thread the other end of nipple l into the cross bar F until snug 4 Place lock washer E over the end of nipple l protruding through cross bar F and thread hex nut D onto nipple until tight 5 Take this crossbar assembly and mount to ceiling outlet box A using outlet box screw H tightly The side of cross bar marked with GND must face out 6 Use a pair of pliers to open one end link of the chain and connect to the fixture loop A Close the link 7 By measuring determine correct number of links needed for proper hanging height Using pliers disconnect and discard remaining chain 8 Lace the fixture wires through the chain 9 Slip collar ring2. L over the chain then do the same with canopy k 10 Open the other end link of the chain and connect to the collar loop F Close the link 11 Feed the fixture wires through the collar loop J and nipple 1 and pull until taut SOCKET C CONNECTING THE WIRE See fig 3 1 Take the black wire from the ceiling outlet box and the smooth Wire leg from the fixture and twist bare ends together Twist wire connector onto end of wire until snug 2 Repeat same process with white junction box wire and ribbed wire leg of fixture wire NOTE Twist wire together in the same direction then twist the wire connector onto wire 3 If your outlet box has a grounding wire Green or bare Copper Attach this wire and the bare copper wire from the Fixture together as step 1 If outlet box has no ground wire lt gt prue lt gt Attach the bare copper fixture wire to the green ground WIRE WIRES A if WETTE OM screw on the cross bar peta RIBBED 4 Tuck these wires connectors neatly into the ceiling out let l HOUSE box and raise the collar ring L and thread onto collar loop J protruding through canopy Your installation is now complete Return power to the junction box and test the fixture american lighting association
Download Pdf Manuals
Related Search