Minka Lavery 1545-77 Instructions / Assembly
Contents
1. gel THE WIRES Fig 2 7 At this point connect the electrical wire as shown in figure 2 making sure that all wire connectors are secured lf your outlet box has a ground wire green or bare copper connect the fixture s ground wire to it Otherwise connect the fixture s ground wire directly to the mounting plate using the green screw provided Rod W35 1 3 F FINISHING THE INSTALLATION Fig 1 W35 H 1 F 8 Place canopy D over the mounting plate A and secure with screws C Spanner WRH T1 51 Set A 021 126102 9 Place the glass shades J and metal rings M Mounting Plate over the socket and secure with socket rings K Socket Ring SKT RING 26_ Ground Screw _ by using spanner L provided Mounting Screw 2 10 Install the light bulb s not included in accordance with the fixture s specifications DO Fi 2 NOT EXCEED THE MAXIMUM WATTAGE 19 RATING NE PAS DEPASSER LA PUISSANCE WIRES NOMINALE MAXIMALE Smooth Your installation is now complete Return power to the outlet box and test the fixture Note Illustration Fig 1 on this manual is for installation purposes only It may or may not be identical to the fixture purchased Notice It is important to use proper chain pliers not ell FIXTURE WIRES ae Bare Copper Ground Green included eg l0 OPEN and CLOSE the chain included with this fixture ye Do not open them with other tools that may twist or str2. INSTALLATION INSTRUCTIONS ltem 1545 New 08 29 2013 READ AND SAVE THESE INSTRUCTIONS WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR HANGING THE FIXTURE Fig 1 Fig 1 1 Shut off the power at the fuse box or circuit breaker If necessary remove the old fixture including the mounting hardware 2 Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration 3 Attach the mounting plate A to the outlet box using two mounting screws B Size 8 32N L0 5 The side of the mounting plate marked GND must face out 4 Place threaded rod H onto fixture body I and place metal tube G over the threaded rod H then place the nut N1 over the metal tube G and carefully pull the fixture s wire through the nut Nipple 1 Outlet Box Nipple 2 1 8 IP 27N 5 Determine the desired length and thread the rods gt F F and nipple 1 to nut N1 fasten the nut N2 1 4 IP 18N Nii and nipple 2 to the end of rods F then secure the loop E to the end of rods F 6 By measuring determine correct number of links Fs N1 needed for proper hanging height Using a pair of chain pliers disconnect and discard remaining chain Then attach the chain to loop E and the loop on canopy D Carefully lace the fixture wires through the chain loop E and the loop on canopy D sa
3. ess i k the chain links It is important to use proper chain pliers like terte the ones shown in the diagram LA 1832E association
Download Pdf Manuals
Related Search