Minka Lavery 5310-2-299 Installation Guide
Contents
1. Crossbar Ground screw Junction box screws 2 Supply Ground Wire Threaded Cross Hex Box Nipple bar nut screw Fixture wire Outlet Box l S pan aie Supply wire Fixture Ground Ground Wire screw Fig 2 FIXTURE FIXTURE WIRES ai WIRES Black or 4 Smooth FIXTURE paR WIRES iis A White or jc Bare EN Ribbed Copper HOUSE Ground HOUSE WIRES WIRE White Neutral Green or Bare Copper Ground Intertek WIRING Fig 2 1 Connect the electrical wires as follows Connect the black wire from the fixture to the black house hot wire Connect the white wire from the fixture to the white neutral house wire Make sure all wire nuts are secured You may wrap the connections with electrical tape If your outlet box has a ground wire green or bare copper connect fixture s ground wire to it Otherwise attach the bare copper fixture wire to the green ground screw Size 8 32 3 8 L on the crossbar 2 Tuck the wire connections neatly into the wall junction box american lighting association2. INSTALLATION INSTRUCTIONS FOR 5310 2 299 For Wall Mount Fixture WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR MOUNTING THE FIXTURE INSTALLATION Fig 1 1 Shut off the power at the circuit breaker and remove the old fixture from ceiling including the old crossbar 2 Carefully unpack the new fixture and lay all the parts on a clear surface 3 Attach the crossbar to the junction box using two junction box screws Size 8 32 1 L The side of the crossbar marked GND must face out 4 Thread the nipple part way into the center hole of the crossbar and secure with hex nut 5 Mark the location for plastic anchors on wall Be sure to check for level before installing plastic anchors mount the plastic anchor to the wall 6 Follow wiring instructions carefully see fig 2 7 Place the fixture body G over the nipple then tighten it with cap nut F 8 Use the wood screw to tighten the back plate of the fixture body G 9 Place the glass plate C onto the fixture body G aligning the hole attach the collar ring E and lock securely with the screw D 10 Install the light bulbs not included in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE _ 11 Attach the shade B to the fixture body G and secure with the screws A Fig Set A A 016
Download Pdf Manuals
Related Search