Minka Lavery 1137-84 Instructions / Assembly
Contents
1. on the mounting plate A to prevent the fixture from turning CONNECTING THE WIRES Fig 2 8 At this point connect the electrical wires as shown in figure 2 making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the ground wires from the hanger ball and mounting plate to it Otherwise connect the ground wire from the hanger ball directly to the mounting plate ground wire and secure with Fig 2 the wire connectors provided After wires are connected tuck them carefully into the ceiling ni To j j FIXTURE FIXTURE junction box WIRES LARES E COMPLETING THE INSTALLATION Fig 1 a White Green or Bare 1 Copper Ground 9 Raise the canopy C to the mounting plate A and align the mounting screws D to the slots L Then turn canopy C clockwise until mounting screws D are in the narrow part of slots L Tighten mounting screws D with a screwdriver 10 Install the li2. INSTALLATION INSTRUCTIONS FOR 1137 84 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER _ AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR READ AND SAVE THESE INSTRUCTIONS PREPATION Fig 1 1 Shut off the power at the fuse box or circuit breaker box If necessary remove the old fixture including the Set LTG BKT 10 mounting hardware tr i Mounting strap 2 Carefully remove the new fixture from the carton and NVI i Ground screw check that all parts are included as shown in the Pty Mounting screws 2 illustration y Junction box screws 2 ASSEMBLING THE FIXTURE Fig 1 3 Determine the desired hanging height and thread rods G H I J onto the nipple K Carefully pass the wires through each rod as you assemble Please remove the nipple if installing with one 6 or 12 rod only 4 Loosen the screws D Size 5 32 0 4 L and remove the canopy C 5 Slip the canopy C over the last rod installed and thread the nipple F onto the top of the rod MOUNTING THE FIXTURE Fig 1 6 Raise the mounting plate A to the junction box not provided then secure with the junction box screws B Size 8 32 0 6 L The side of the mounting plate marked GND must face out 7 Install the fixture body into the mounting plate A by tilting at a slight angle so that the hanger ball E slips into the mounting plate A as shown Align the notch in the hanger ball E to the tab
3. ght bulbs included in accordance with piece the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE l l l I I Neutral l Note Press spring coupling M by hand and adjust to the desired length of steel wire N Your installation is now complete Return power to the H lightin junction box and test the fixture i ngang association
Download Pdf Manuals
Related Search