Minka Lavery 4355-593 Instructions / Assembly
Contents
1. 0 P Fig 3 FIXTURE FIXTURE FIXTURE WIRES WIRES WIRES Black or White or Bare EONS Smooth gt Ribbed Copper HOUSE HOUSE Ground HOUSE WIRES WIRES WIRES Black White Green or Hot Neutral Bare Copper Ground CHAIN HUNG FIXTURE INSTRUCTION Notice It is important to use proper chain pliers not included To OPEN and CLOSE the chain included with this fixture Do not open them with other tools that may twist or stress the chain links It is important to use proper chain pliers like the ones shown in the diagram gt american lighting r association Intertek2. INSTALLATION INSTRUCTIONS FOR 4355 593 WARNING SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR ASSEMBLING THE FIXTURE Fig 2 1 Shut off the power at the circuit breaker and remove the old fixture from ceiling including the old crossbar 2 Carefully unpack the new fixture and lay all the parts on a clear surface 3 Attach the loop I to the fixture body O by turning it clockwise until tight 4 Attach the tube N and the shade L onto the socket of fixture body O and then lock it securely with the check ring J HANGING THE FIXTURE Fig 1 5 Thread the nipple C into the loop F until snug 6 Thread the other end of the nipple C with the loop attached into the crossbar D until snug 7 Place lock washer B over end of nipple protruding through crossbar and thread hex nut A onto nipple until tight 8 Take this crossbar assembly and mount to ceiling junction box with junction box screws E Size 8 32 1 2 L Tighten screws securely with screwdriver 9 Using proper chain pliers to open one end link of the chain provided and connect to the fixture loop I then close the link 10 By measuring determine correct number of links needed for proper hanging height Using proper chain pliers disconnect and discard remaining chain 11 Lace the fixture wires through the chain 12 Slip loop collar H and the canopy G over the cha
3. in 13 Open the other end link of the chain and hang the fixture on the loop at the ceiling Close the link 14 Feed the fixture wires through the loop F and nipple C and pull until tight CONNECTING THE WIRES Fig 3 15 Connect the electrical wire as shown in figure 3 making sure that all wire connectors are secured If your outlet has a ground wire green or bare copper connect the fixtures ground wire to it If the junction box has no ground wire attach the bare copper fixture wire to the green ground screw Screw 8 32 3 8 L on the crossbar Tuck the wire connections neatly into the ceiling junction box COMPLETING THE INSTALLATION Fig 1 and Fig 2 16 Raise the canopy G all the way to the ceiling then raise the loop collar H and thread into ceiling loop protruding through canopy 17 Install the light bulbs not included in accordance with the fixture s specifications DO NOT EXCEED THE MAXIMUM WATTAGE RATING NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE 18 Hang the crystals M and the crystals P to the loop of the fixture body O 19 Hang the crystal K to the bottom of the fixture body O Your installation is now complete Return power to the junction box and test the fixture Fig 1 Junction Box Ceiling OD d gt Set A A 012 Crossbar Ground screw Junction box I ies eo eeo F screws 2 Chain HCH3072 593 Gauge 4 2mm Dia 72 Fig 2 N L I M
Download Pdf Manuals
Related Search