Aspects TPUW70050LWH Installation Guide
Contents
1. Wall Pack LED Wall Sconce Model 326914 amp TPUW70050LWH 120VAC 60Hz Safety Precautions This fixture is designed for use in a 110 120VAC 60Hz fused circuit Read all safety precautions and installation instructions carefully before Do not use on a dimming circuit installing or servicing this fixture Failure to comply with these instructions could result in potentially fatal electric shock and or property damage To reduce the risk of electrical shock and to assure proper operation this fixture must be adequately grounded To accomplish proper grounding there must be a separate ground wire green contact fixture must be wired in accordance with all national and local supply panel electrical codes ee o o l l l l This fixture is intended to be used for general outdoor lighting in dry or Do not handle any energized fixture or attempt to energize any fixture damp locations only with wet hands or while standing on a wet or damp surface or in water ASSEMBLY INSTRUCTIONS 1 Preparing for installation A Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture B Carefully remove the fixture from the carton and check that all parts are included as shown in figure below Be careful not to misplace any of the screws or parts which are needed for installing the fixture 2 Wiring all wiring must take place inside junction box Caution Make sure power is off at fu2. ormal operating conditions for a period of 2 years from date of purchase This warranty covers all component parts and extends only to replacement of defective fixture or components it does not cover failure due to improper installation misuse mishandling or damage incurred in transit 1 of 1 American 8060663 R2 Fluorescent l design efficiency technology
3. se or circuit breaker box Check power wires for damage or scrapes If power supply wires are within three inches of the ballast power supply use wire suitable for at least 90C 194F Note Most dwellings built before 1985 have supply wire rated to 60C Consult a qualified electrician before installing EON N LN A Secure gem bar 1 on the junction box not supplied S alee with two screws 3 supplied B Make all wire connections to appropriate wire Secure with wire nuts supplied C Connect the green wires from the fixture and power source to the green screw on the gem bar 1 D The black wire from the fixture is connected to the black wire from power source E The white wire from the fixture is connected to the white neutral wire from power source F Tuck all connections neatly into junction box 3 Mounting A Thread nut 2 on stem 4 Adjust the length of the stem in the gem bar so that approx 7 8 is exposed Secure the necessary length with nut 2 B Install back panel 5 over stem 4 and secure it with the thumbnut 6 4 Shade To install the lens 7 align the four holes on the diffuser with the four holes on the top and the bottom of the backpan Secure lens with four screws 8 5 Restore power at fuse or circuit breaker box Limited Factory Warranty American Fluorescent Corporation warrants this fixture is free from defects in materials and workmanship when installed and used under n
Download Pdf Manuals
Related Search