Sea Gull Lighting 9858-962 Installation Guide
Contents
1. INSTALLATION AND SAFETY INSTRUCTIONS HC 207 U S PATENT 5 465 199 FOR YOUR SAFETY WARNING BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF EITHER THE FUSE REMOVED OR THE CIRCUIT BREAKER OFF RISK OF FIRE Exceeding maximum wattage may result in over heating conductors Read instructions carefully If you are unclear as to how to proceed consult a qualified electrician CAUTION RISK OF FIRE Use only 12V lamps with 12V systems Use of 12V lamps with 24V system may result in damage to the b lt screws 2 system and surrounding area CAUTION RISK OF FIRE Must use Sea Gull No 9488 fused plug if RETAINING SPRING 2 used with transformers over 60w at 12 volts or 100w at 24 volts USE ONLY WITH AMBIANCE 105 CABLE FIXTURE WIRE SURFACE MOUNTING 1 Secure surface mount ring to surface by marking hole location on surface ___ and screw surface mount ring to surface making sure surface mount ring does not flex out of round FIXTURE HOUSING SLOTS 4 GB 2 Drill wire exit hole in surface or run wire thru notch in surface mount ring HOOKS 2 3 Line up retaining springs on fixture housing with grooves in surface mount ring and press fixture housing into surface mount ring MIRIM lt 23 4 1 Drill a 2 3 4 dia hole in surface SSS 18 2 Press fixture housing into eee ee ae NOT INCLUDED 2 3 4 dia hole FUSED PLUG INSTALLATION NOT INCLUDED Cut wire to desir2. ctly hook up three 3 9485 to the junction box as in Figure 1 2 Fora run larger than three 3 disk lights you must use a class transformer larger than 60w The following example demonstrates a run of eight 8 9485 disk lights 8 x 16 2w each 130w in this case you will need to use a 150w transformer FIGURE 1 Figure 2 demonstrates fusing each individual disk light with a 9488 fused plug 9488 8 FUSED PLUGS TRACK amp CABLE 9485 8 FIGURE 2
3. ed length Split ends of wire about 1 2 and insert each end of the wire as far as possible into the plug Do not strip any insulation off the wire Insert contact into one end of plug and press or use pliers until contact is flush with plug Repeat with other contact see illustration Twist wires sideways insert into notch in plug and twist back straight Snap plug on cable Install lamp 18w max not included NOT INCLUDED N a A kag Da TRIM INSTALLATION Secure trim not included to fixture housing by inserting NOT INCLUDED hooks on trim into two of the four slots in fixture housing and twist clockwise until trim snaps in place Bend hooks up FUSED slightly max 1 8 if trim is too hard to turn and lock into ae position on housing WARNING Use of other manufacturers components will void warranty U L listing and create a CABLE potential safety hazard RISK OF FIRE DO NOT REMOVE REFLECTOR ye CAUTION RISK OF FIRE 12V LAMPS MUST NOT BE USED IN A 24V SYS TRACK TEM INSTALL CABLE SO THAT CAUTION PRINTED ON CABLE IS VISIBLE AFTER INSTALLATION AND ATTACH THE 24V CAUTION LABELS SUPPLIED WITH THE 24V TRANSFORMER ON OR ALONG THE TRACK EVERY 4 FT h 031606 FINAL INSTALLATION AND FUSING HC 207 There are several ways to install the 9485 disk lights using the 9774 18w 12V xenon lamps actual consumption 16 2w 1 When using a 60w max transformer class II you are able to dire
Download Pdf Manuals
Related Search