TroposAir 422 Instructions / Assembly
Contents
1. ee Fan Speed Figure 3 Wall Control Operation Setthe fan onits high speed pull chain setting Then use your wall controlto select any ofthe 3 speeds and OFF NOTE If your fan has the original pull chain switch please always have the fan switch set to high speed before using the wall control To avoid accidental pull chain use shorten chain by cutting 1 inch below switch body2. GULF COAST FANS INC Fan Speed Wall Control Installation Instructions IMPORTANT READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL THIS ELECTRICAL DEVICE Installation of this control requires that a three conductor cable with ground wire be run between the control wall box andthe ceiling fan outlet box WARNING _ 7 TOAVOID FIRE SHOCKAND SERIOUS PERSONAL INJURY FOL LOW THESE INSTRUCTIONS READ YOUR OWNER S MANUAL CAREFULLY RETAIN OWNER S MANUAL FOR FUTURE REFERENCE TO AVOID POSSIBLE ELECTRICAL SHOCK BE SURE ELECTRICITY IS TURNED OFF AT THE FUSE BOX OR CIRCUIT BREAKER PANEL BEFORE INSTALLING THE WALL CONTROL DO NOT INSTALL WALL CONTROL NEAR HEAT PRODUCING EQUIPMENT ALL WIRING MUST CONFORM TO NATIONAL AND LOCAL ELECTRICAL CODES IF YOU FEEL YOU DO NOT HAVE ENOUGH ELECTRICAL KNOWLEDGE HAVE ALICENSED ELECTRICIAN INSTALL THE CONTRAL USE OF THIS CONTROL WITH SOME CEILING FANS COULD RESULT IN FIRE SHOCKAND SERIOUS PERSONAL INJURY USE THIS SPEED CONTROL ONLY WITH CAPACITOR SPEED CONTROLLED CEILING FANS General Instructions _ This fan speed wall control is rated for 2 amps at 120volts Itis designed to control 2 of ceiling fans operation _ _ To connect more than one fan to this wall control your ceiling outlet boxes must be wired to one central wall outlet Additional wiring may needed make these connections We suggest that you calla licensed electrician if you need to control more
3. than one fan To avoid erratic speeds and possible damage to your fan use this control only with the fan pull chain switch set to its highest speed setting Installation Electric connections should be in accordance with the national electrical codes and all local codes Before starting disconnect power to the circuit at the fuse box or circuit breaker box 1 Disconnect the power and remove the existing wall plate and switch Figure 1 2 Setthe fan speed wall control in the OFF position Switch is in down position yaa 1 OUTLET BOX WALL PLATE Sach 3 Make wire connections and secure them with wire nuts supplied as follows REFER TO Figure 2 Connect the one of the black wires from all control to the black hot wire in outlet that comes from the household power supply top wire Connect the other black wire from the wall control to the other black wire bottom wire This wire goes up to the ceiling s outlet box where your fan is installed Use wire nuts supplied to secure the electrical connections Wire the fan according to instructions in the ceiling fan s Instailation Instruction Figure 2 i i i x ws gute i amz E Wire to House s i Power Supply H f 4 lt Fan BLACK i 1 Light ra Switch i on Wall 4 Wall ai BLACK 4 Figure 3 Attach the Speed Wall Control to the outlet wall box and secure with 2 outlet box screws
Download Pdf Manuals
Related Search