Hampton Bay 16666-023 Installation Guide
Contents
1. any d cor Standard 72 wire 60 cable for open entry way and cathedral ceiling installations QUESTIONS PROBLEMS MISSING PARTS Before returning to your local Home Depot please call our Customer Service Team at 1 877 527 0313 or visit www homedepot com Please reference your SKU 601 665 or UPC 773546217453 CAUTION 1 Before starting installation of this fixture or removal of a previous fixture disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box 2 CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS 3 If you have any non electrical questions about this fixture please contact our Customer Service Team at 1 877 527 0313 or visit www homedepot com Please reference your SKU 601 665 or UPC 773546217453 4 Keep your receipt and these Instructions for Proof of Purchase Page 2 INSTALLATION 1 Junction Box not included White Wire 3 Wire Nut x3 I Ground Wire Black Wire 2 Mounting Plate 4 Mounting Screw x2 5 Ground Screw 6 Canopy L l D fh Hl Tl ip 7 Side Screw x2 IA STANT IN w MV ce L L 8 Cable Restraint n 9 Wire Restraint e a os Figure 1 FROM HOUSE l BLACK OR RED WIRE A BLACK OR SMOOTH l FROM FIXTURE l l FROM FIXTURE l l l FROM HOUSE l GROUND WIRE GROUND WIRE FROM HOUSE FROM FIXTURE ADDITIONAL PARTS FOR INSTALLATION includ2. the tip NOTE All wire connections should be made with wire nuts or marettes included and pushed back into junction box 1 See Figure 1 8 Mount canopy of pendant 6 over mounting backplate 2 and secure with side screws 7 supplied Page 6 Page 3 ASSEMBLY INSTRUCTIONS 1 Carefully unpack the fixture lay out all parts on a clean surface 2 Install A19 Bulb 60W max not included 3 Carefully unwrap one package of Capiza shell at a time 4 Install alternatively the capiz shell strands A consisting of 11 and 12 pcs each onto the inner frame 10 5 Install alternatively the capiz shell strands B consisting of 7 and 8 pcs each onto the outer frame 12 Page 4 ASSEMBLY 6 Canopy Socket 7 Side Screw x2 8 Cable Restraint 9 Wire Restraint che H OOOO Tt A19 Bulb 60W max not included HTS o o o o Q 10 Inner Frame 12 Outer Frame Strand A Strand B Page 5
3. TROUBLESHOOTING i al Possible Cause Corrective Action 1 Bulb is burned out 1 Replace light bulb Bulb will not light 2 Switch is off 2 Make sure switch is on 3 Faulty wire connection 3 Check wiring Crossed wires or power wire is grounding out Fuse blows or circuit breaker trips when light is turned on Check wire connections PRODUCT MAINTENANCE 1 To clean the outside of the lamp use a dry or slightly dampened clean cloth use clean water never a solvent to wipe the shade and surface of the lamp 2 To clean the inside of the fixture first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box Next use a dry or slightly dampened clean cloth use clean water never a solvent to wipe the inside shade and interior surface of the fixture 3 Do not use any cleaners with chemicals solvents or harsh abrasives Use only a dry soft cloth to dust or wipe carefully LIMITED WARRANTY The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five 5 years from date of purchase This warranty applies only to the original consumer purchaser and only to products used in normal use and service If this product is found to be defective the manufacturer s only obligation and your exclusive remedy is the repair or replacement of the product at the manufacturer s discretion provided that the product has not been dam
4. aged through misuse abuse accident modifications alterations neglect or mishandling This warranty shall not apply to any product that is found to have been improperly installed set up or used in any way not in accordance with the instructions supplied with the product This warranty shall not apply to a failure of the product as a result of an accident misuse abuse negligence alteration or faulty installation or any other failure not relating to faulty material or workmanship This warranty shall not apply to the finish on any portion of the product such as surface and or weathering as this is considered normal wear and tear The manufacturer does not warrant and specially disclaims any warranty whether express or implied of fitness for a particular purpose other than the warranty contained herein The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage including but not limited to any labor expense costs involved in the replacement or repair of said product Page 8 INSTRUCTION MANUAL INTERIOR 2 LIGHT PENDANT RAZZARI HOME DEPOT SKU 601 665 S O 435 068 UPC 773546217453 CHROME FINISH Page 1 Thank you for purchasing this Hampton Bay interior decorative lighting This product has been manufactured with the highest standards of safety and quality FEATURES Refined capiz shell strands radiate a simple elegance to this fixture that complements
5. ed TOOLS REQUIRED FOR ASSEMBLY amp INSTALLATION not included 2 Mounting Plate 3 Wire Nut x3 4 Mounting Screw 5 Ground Screw Safety Goggles Wire Stripper Wire Cutters Flathead x2 Screwdriver A 6 Canopy 7 Side Screws x2 Phillips Electrical Tape A19 Bulb 60W Screwdriver Max not included POLAT EATON ST RUE TIOS ADDITIONAL PARTS FOR ASSEMBLY included Turn off power at main fuse box 2 While depressing cable restraint 8 on pendant canopy 6 push or pull on cable depending if you want to raise or lower your height Do this adjustment prior to installation U Re attach the cable stopper which is located at the end of the suspension cable at the new height This is an added safety precaution Sianu A Sra 4 Push excess clear cord up into canopy 6 leaving a little slack to form an S pattern by unfastening the wire restraint 9 mounted on canopy 6 and then refasten wire restraint 9 once proper wire length is achieved Nn Install mounting backplate 2 to junction box 1 with 2 screws supplied an Fasten open end of ground wire bare copper or green wire to ground wire or ground screw of junction box 1 or ground screw 5 on mounting backplate 3 N Connect black wire of power supply to the wire of the chandelier marked in Black coded at the tip and connect white wire of power supply to the wire of the chandelier left in clear or marked in White coded at
Download Pdf Manuals
Related Search