Hampton Bay 1000051635 Instructions / Assembly
Contents
1. 1 855 HD HAMPTON CAUTION Suitable for damp locations Not for use with dimmers CAUTION Use only on 120 volt 60Hz circuits Not for use where directly exposed to the weather Starting temperature 20 F Optimum operating temperature 10 F to 140 F This device is not intended for use with emergency exit fixtures or emergency exit lights Do not use with dimmers photocon trols or electronic timers Never use more than 25 lamps per 20 amp branch circuit WARNING Before starting installation of this fixture or AN removal of a previous fixture disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box Warranty The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five 5 years from date of purchase This warranty applies only to the original consumer purchaser and only to products used in normal use and service If this product is found to be defective the manufacturer s only obligation and your exclusive remedy is the repair or replacement of the product at the manufacturer s discretion provided that the product has not been damaged through misuse abuse accident modifica tions alterations neglect or mishandling This warranty shall not apply to any product that is found to have been improperly installed set up or used in any way not in accordance with the instructions supplied with the product This warran2. BAY COM 3 Please contact 1 855 HD HAMPTON for further assistance Assembly 1 Assembling the floor lamp LJ Start by screwing the bottom pole H to the base I and the center pole G to the bottom pole H L1 Pull the slack from the power cord as required O Connect the top pole F to the center pole G L1 Pull the slack from the power cord as required 2 Connecting the socket assembly O Connect the socket assembly E to the top pole F L1 Pull the slack from the power cord as required E e i gt F 3 Installing the harp L1 Install the harp B into the socket assembly E B E 4 Installing the lamp shade and light bulb L1 Place the lamp shade C over the screw at the top of the harp Secure the lamp shade C with the finial A O Install one 23 watt max CFL bulb included with item 1000051635 Operation 1 Turning the light on O Turn the light switch on to activate the fixture Care and Cleaning O Clean the lamp with a soft dry cloth O Do not use any cleaners with chemicals solvents or harsh abrasives Troubleshooting Problem Possible Cause Solution The bulb will not light The bulb is burned out Replace the light bulb The power is off Ensure the power supply is On There is a faulty wire connection Check the wiring The circuit breaker is off Ensure the circuit breaker is
3. Item 1000051631 1000051635 Model F319001A ROB CFL F319001A ROB USE AND CARE GUIDE SWING ARM FLOOR LAMP Y E D Questions problems missing parts Before returning to the store call Hampton Bay Customer Service 8 a m 6 p m EST Monday Friday 1 855 HD HAMPTON HAMPTONBAY COM THANK YOU We appreciate the trust and confidence you have placed in Hampton Bay through the purchase of this floor lamp We strive to continually create quality products designed to enhance your home Visit us online to see our full line of products available for your home improvement needs Thank you for choosing Hampton Bay Table of Contents Table of Contents eese esce eres 2 Package Content score cecidere 3 Safety Information eene 2 Assembly acne nA QUA Ada ee 4 Licht 2 OperatlOFi caruit tnnt tremere rae tate ko kn Rc 5 Pre Assembly Q 3 Care and Cleaning eene 5 Planning Assembly renes 3 Tre bleshaootilg uciciooei t nad ee Cx c eben 5 Safety Information O Consult a qualified electrician if you have any electrical CAUTION Inspect the wire insulation for any cuts questions abrasions or exposed copper that may have resulted during shipping If there is a defect in the wire do not attempt installation Please call our Customer Service Team at
4. in the On position The fuse blows or circuit breaker trips when the light is turned on There are crossed wires or the power wire is grounding out Check the wire connections Contact a qualified electrician or call the Customer Service Team at 1 855 HD HAMPTON HAMPTONBAY COM 5 Please contact 1 855 HD HAMPTON for further assistance Questions problems missing parts Before returning to the store call Hampton Bay Customer Service 8 a m 6 p m EST Monday Friday 1 855 HD HAMPTON HAMPTONBAY COM Retain this manual for future use
5. ty shall not apply to a failure of the product as a result of an accident misuse abuse negligence alteration faulty installation or any other failure not relating to faulty material or workmanship This warranty shall not apply to the finish on any portion of the product such as surface and or weathering as this is considered normal wear and tear The manufacturer does not warrant and specially disclaims any warranty whether express or implied of fitness for a particular purpose other than the warranty contained herein The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage including but not limited to any labor expense costs involved in the replacement or repair of said product Contact the Customer Service Team at 1 855 HD HAMPTON or visit www hamptonbay com Pre Assembly PLANNING ASSEMBLY L1 Read all instructions before assembly O To avoid damaging this product assemble it on a soft non abrasive surface such as carpet or cardboard Ol Keep your receipt and these instructions for proof of purchase PACKAGE CONTENTS E 5 Description Quantity Finial 1 Harp Lamp Shade Bulb only included with item 1000051635 Socket Assembly Top Pole Center Pole Bottom Pole Base IIo nim olol l d l l HAMPTON
Download Pdf Manuals
Related Search