Kenroy Home 50325DT Installation Guide
Contents
1. ADJACENT WALL FOR MOISTURE BUILD UP AND CLEAN AS NECESSARY THIS IS ESPECIALLY IMPORTANT FOR HUMID ENVIRONMENTS THIS FOUNTAIN IS RATED FOR OUTDOOR USE THIS UNIT MUST BE CONNECTED TO SUPPLY CIRCUIT THAT IS PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER THE SHOULD TESTED ROUTINE BASIS TO TEST THE GFCI PUSH THE TEST BUTION THE SHOULD INTERRUPT POWER PUSH THE BUTION POWER SHOULD RESTORED IF THE GFCI FAILS TO OPERATE IN THIS MANNER THE GFCI IS DEFECTIVE AVAILABLE PARTS ARE PUMP1008 PUMP TRANS2002 TRANSFORMER 53205BLB BULB 50325DT INSTRUCTIONS PAGE 3 32. SERVOIR ASSEMBLY INTO LOWER RESERVIOR MAKE SURE PUMP SIT FLAT IN LOWER RESERVOIR RESERVOIR ASSEMBLY REPLACEMENT PART 50325DT INSTRUCTIONS PAGE 2 3 voz 20 5250 ASSEMBLY 5 5 READ AND SAVE THESE INSTRUCTIONS FOUNTAIN ASSEMBLY 7 FILL RESERVOIR WITH 5 GALLONS OF WATER TO COMPLETELY SUBMERSE THE PUMP NOTE DISTILLED WATER IS RECOMMENDED TO REDUCE MINERAL DEPOSITS AND BACTERIA BUILD UP JOIN THE CONNECTORS TRANSFORMER AND SCREW THE CAP TO CONNECTOR TIGHTLY TOGETHER RESERVOIR LIGHT TRANSFORMER TRANS2002 REPACDEN L gt PART 9 PLUG PUMP POWER CORD AND TRANSFORMER INTO SOCKETS YOUR NEW FOUNTAIN IS READY FOR USE 02 2012 TROUBLE SHOOTING 1 IF YOUR FOUNTAIN DOES NOT WORK CHECK PLUG AT THE 5 SURE THE PLUG 15 FULLY AND PROPERLY INSERTED INTO THE WALL OUTLET 2 NEXT CHECK SURE THE OUTILET IS POWERED 5 IF THE FOUNTAIN DOES PLEASE CONTACT YOUR DISTRIBUTOR OR PLACE OF PURCHASE SPLASHING DISCLAIMER SPLASHING MAY OCCUR WHEN FOUNTAIN IS INITIALLY PROTECT SURROUNDING SURFACES AS NEEDED IMPORTANT PUMP INFORMATION PUMP MUST BE FULLY SUBMERSED IN WATER WHILE OPERATING WATER REDUCE MINERAL DEPOSITS AND BACTERIA BUILD UP THE USE OF DISTILLED WATER IS RECOMMENDED WARNING ONCE A WEEK INSPECT FOUNTAIN FLOOR AND
3. voz 20 5250 ASSEMBLY 5 5 READ AND 5 THESE INSTRUCTIONS READ INSTRUCTIONS ALL THE WAY THROUGH PRIOR TO ASSEMBLY THIS FOUNTAIN SHOULD TAKE APPROXIMATELY 20 MINUTES TO ASSEMBLE MAKE SURE ALL PARTS ARE FIRMLY TIGHTENED CAUTION TWO PEOPLE REQUIRED TO LIFT AND ASSEMBLE THIS FOUNTAIN UNPACK THE FOUNTAIN YOU SHOULD HAVE THE FOLLOWING PARTS UPPER COLUMN UPPER RESERVOIR LOWER COLUMN LOWER RESERVOIR BASE PUMP 2 SPOT LIGHTS 2 EXTRA BULBS AND TRANSFORMER FOUNTAIN ASSEMBLY 1 PLACE LOWER RESERVOIR ON TOP OF BASE AND ROTATE THE LOWER RESERVOIR CLOCKWISE TO SECURE 02 2012 2 FEED THE PUMP POWER CORD AND LIGHT POWER CORD THROUGH THE PLASTIC TUBE TOWARD BOTTOM OF BASE CORD EXITS OUT FROM CHANNEL ON THE BOTTOM OF THE BASE PUMP POWER CORD POWER CORD PLASTIC 5 PLACE PUMP FLAT IN LOWER RESERVOIR AND PLACE 2 SPOT LIGHTS INTO SPOT LIGHT HOLDERS SPOT LIGHT 53205BLB REPLACEMENT HOLDER 2 PCS 50325DT INSTRUCTIONS PAGE 1 3 voz 20 5250 ASSEMBLY 5 5 READ AND SAVE THESE INSTRUCTIONS FOUNTAIN ASSEMBLY 4 PLACE UPPER RESERVOIR ONTO TOP OF LOWER COLUMN AND ROTATE THE UPPER RESERVOIR CLOCKWISE TO SECURE RESERVOIR p OWER COLUMN PLACE UPPER COLUMN INTO UPPER RESERVOIR PPER COLUMN PPER RESERVOIR 02 2012 LIFT THE UPPER RESERVOIR ASSEMBLY ATTACH RUBBER HOSE TO PUMP THEN PLACE UPPER RE
Download Pdf Manuals
Related Search