Kingston Brass HGKTD332210 Installation Guide
Contents
1. STEP 4 Recommended for professional installers only Install faucets and other accessories such as a side spray or soap lotion dispenser onto the sink Do not install drainer basket until the sink is in place ADDITIONAL HOLE KNOCKOUTS FOR SINKS Please be sure to make any additional accessory holes before sink installation 1 Holes for faucet fixtures and accessories have been pre drilled from underneath and are marked on the top surface by white dots centered above the holes Make sure you check the current position of the dots before you hammer as dots may shift in very hot weather 2 Put the foam packing parts back into the box and place sink on top of box 3 Tap the white dots over the pre cut holes lightly with a 6 ounce ball peen hammer While holding your hand against the underside of the hole to support the sink 4 Trim the hole with the small end of the ball peen hammer or use a fine file WARNING WARRANTY WILL BE VOIDED IF THESE INSTRUCTIONS ARE NOT FOLLOWED STEP 5 Recommended for professional installers only Snap mounting clips into position on the sink at evenly spaced intervals STEP 6 Recommended for professional installers only Run a bead of the appropriate sealant inside the masking tape STEP 7 Recommended for professional Installers only Lower the sink into the hole following the guidelines created by the masking tape Turn mounting clips against the underside of the guidelines created an2. d tighten with screw driver STEP 8 Recommended for professional Installers only Remove excess sealant if any Install strainer basket 201 2 04 L Kingston Brass www kingstonbrass com TOLL FREE CUSTOMER SERVICE 1 877 2 KBRASS TECHNICAL SUPPORT E mail service kingstonbrass com 12715 Reservoir Street Chino CA91 710 KINGSTON BRASS INSTALLATION INSTRUCTIONS SELF RIMMING SINK These instructions are for installing Kingston Brass self rimming stainless steel sink and self rimming Sinks are sinks that are installed from above the countertop and sealed to the top of the counter If you are Installing another type of sink such as an undermount sink which sits below the countertop please refer to instructions specifically for those sinks Templates are supplied only as a guide The physical use of the sink will ensure a more accurate cutout Note It is recommended that all countertops be cut by an approved or certified installer and that The sinks be installed by the installer whenever possible The countertop sink unit ideally should be Installed as one on the jobsite Before installing the sink inspect it for damage Do not install a damaged unit Remember itis your responsibility to follow all local plumbing and building codes The warranty will be voided if these installation instructions are not followed STEP 1 Recommended for professional Installers only Cut out the template and place it on the counterto
3. p making sure that the sink front is Parallel to the front of the counter Be sure the sink is properly centered both front to back and side to side Check for adequate clearance relative to cabinet walls and pull out or tilt down drawers Tape the template in place Trace around the template STEP 2 Recommended for professional Installers only Place a brace under the countertop to support the sink cutout area This will also make it easier to do the sink cutout Cut the countertop along the template line with the proper tool for the countertop material STEP 3 Recommended for professional Installers only Trial for the sink by inserting it into the countertop to test whether the cutout is the correct size Mark the edge of the sink with masking tape on the countertop Remove the sink and make any necessary adjustments in the cutout or placement the easiest way to handle the sink is via the drain hole or holes especially if it s a double bow model
Download Pdf Manuals
Related Search