ProTeam 107128 Installation Guide
Contents
1. FILTER ASSEMBLY REPLACEMENT A WARNING For your own safety never connect plug to power source outlet until all assembly steps are complete and you have read and understood the safety and operation instructions Do not operate Vacuum with any parts damaged or missing To Remove Power Head 1 Grasp the tank latches on both the right and left side of the power head Slowly pull the tank latches away from the tank Lift the power head off the tank Place the power head of the Vacuum upside down Figure C Pull Out And Lift Up Figure C ProTeam 7 FILTER ASSEMBLY REPLACEMENT cont A WARNING Do not operate without filter cage and float as they prevent liquid from entering the impeller and damaging the motor IMPORTANT To avoid damage to the blower wheel always reinstall the filter before using the Vacuum for dry material pick up Removal and Installation of Qwik Lock Fine Dust Cartridge Filter Filter Removal 1 Hold the filter tabs of the Qwik Lock Integrated Filter PUSH filter in each hand Figure D Plate with Center 2 With one thumb on the Qwik Lock PIPS stud which protrudes through the i Rubb integrated filter plate lift up on Filter Cokol al the filter tabs while pushing down Bottom of on the stud Filter 3 This action will cause the filter to release from the filter cage Slide Qwik Lock filter off cage Filter Installation 1 Carefully slide the Qwik Lock fi2. lter over the filter cage and press down on the outside edge of the filter until the rubber gasket on the bottom of the filter seats securely around the base of the filter cage and against the lid Figure D 2 Align the small center hole in the top of the filter over the Qwik Lock stud on the filter cage Press firmly on top of the filter near the stud to allow the filter to snap over the ball on the end of the stud The filter is now attached NOTE Failure to properly seat the bottom gasket could result in debris bypassing the filter 8 ProTeam
Download Pdf Manuals
Related Search