MOEN DN7065 Installation Guide
Contents
1. 06 06 2012 SPC12140 500000128120 Released 01 Home Care Technical Specification Tool Free Transfer Bench DN7 065 Stock Numbers a DN7065 Tool Free Transfer Bench White Tool Free Transfer Bench is made of ABS Plastic Aluminum EPDM and Stainless ASSEMBLY TESTED TO CONFIRM ADA COMPLIANCE g WARNING TO PREVENT SERIOUS OR FATAL INJURY Insure productisassembled adjusted and used properly FOR USE ONLY BY PERSONS WEIGHING LESS THAN 250 POUNDS Failure to follow correct assembly and or adjustment procedurescan make the seat unstable ALL FOUR LEGS MUST BE LOCKED IN PLACE AT THE SAME HEIGHT DO NOT jump on stand on or tilt Contact CSI immediately at 1 800 882 0116 if any componentsare missing or damaged Do not modify or substitute any components FOR QUESTIONS ORASSIST ANCE WITH ASSEMBLY CONTACT CSI AT 1 800 882 0116 Consult healthcare professional foradvice and instructionsspecific to users needsbefore use Q Caha Specialtys Ri MOEN ON 10 11 12 Dimensions d s CCD QA JIC 8 4 Installation Instructions Determine orientation of chair relative to w ater supply in order for transfer bench to be positioned outside of bathtub Locate the tw o under seat support beams Hold the pieces by the straight end w ith the curved end aw ay from you Locate the flat indented area of each beam Place the twoflat areas together so they are touching and the tw o beams form2. an X shape Locate the leg unit with top posts that point inw ard Align the posts with the straight ends of the crossed support beams on the small end of the X Slide the top posts of the leg unit over the ends of the crossed support beams Take the remaining leg unit withthe top posts that point straight out and align it w ith the curved end of the support beams at the large side of the X Slide the top posts of the leg unit over the ends of the crossed support beams Locate the transfer bench Place it seat side down Place the curved ends of the crossed support beams into the grooves on the underside of the transfer bench aligning the holes in the support beams with the holes inside the grooves Use the assembly knobs to attach the transfer bench to the support beams Thread the washers onto the bolt small lock w asher first follow ed by the cup w asher Locate the large seat bottom Place it under the support beams so that the center of the X slides into the center of the X shaped grooves on the large seat bottom Stock Number TF Transfer Bench By Creative Specialties 25300 AL MOEN DRIVE e NORTH OLMSTED OH 44070 CORPORATE HEADQUARTERS 800 321 8809 FAX 800 848 6636 INTERNATIONAL 440 962 2000 FAX 440 962 2726 CUSTOMER SERVICE USA 800 882 0116 e FAX 888 379 2720 WWW MOEN COM Copyright Creative Specialties International Literature BA1370
Download Pdf Manuals
Related Search