MOEN LR8724D3GOWB Installation Guide
Contents
1. Home Care Technical Specification Ultima Grab Bar w Curl Grip LR8700D3G Stock Numbers LR8716D3GBN 16 Ultima Grab Bar w Curl Grip Brushed Nickel Finish 1 4 Bar LR8724D3GBN 24 Ultima Grab Bar w Curl Grip Brushed Nickel Finish 1 14 Bar R8736D3GBN 36 Ultima Grab Bar w Curl Grip Brushed Nickel Finish 1 14 Bar Wholesale Packaging R8742D3GBN 42 Ultima Grab Bar w Curl Grip Brushed Nickel Finish 1 4 Bar 42 Bars Wholesale Packaging 42 00 45 15 LR8716D3GCH 16 Ultima Grab 3 15 Bar w Curl Grip Chrome Finish 1 1 2 Bar LR8724DGCH 16 Ultima Grab Bar w Curl Grip Chrome Finish 1 1 2 Bar 040 type 304 stainless steel tubing O International Installation Instructions 1 Please note that screws MUST be mounted into a wood stud for secure installatior a aka 2 Slide the decorative cover away from the hub end to expose the SecureMount R8736D3GCH 36 Ultima Grab Bar mounting flange Do not remove protective plastic from decorative cover until wi Curl Grip er indicated later in these instructions Chrome Finish 1 4 Bar 3 Locate the studs behind the wall by using a stud sensor or other stud locating Wholesale Packaging method Studs are usually 16 in apart locate the center of each stud 4 Moving aside the decorative cover as needed with a pencil mark three of the R8742DGCH 42 Ultima Grab Bar mounting locations on each of the2. e the decorative cover over the SecureMount mounting flange rotating to find the correct fit before snapping into place 10 Slide decorative covers over SecureMount mounting flanges Stock Number Grab Bars By Creative Specialties 25300 AL MOEN DRIVE e NORTH OLMSTED OH 44070 CORPORATE HEADQUARTERS 800 321 8809 FAX INTERNATIONAL 440 962 2000 e FAX 440 962 2726 CUSTOMER SERVICE USA 800 882 0116 FAX 888 379 2720 Copyright Creative Specialties International 800 848 6636
3. two grab bar flanges Two marks to be made w Curl Grip above the grab bar in the area indicated in the illustration below The third mark Chrome Finish 1 4 Bar to be made below the grab bar in the area indicated in the illustration below Wholesale Packaging Decide whether you would like to position your grab bar horizontally vertically or at an angle remembering that BOTH ends of the grab bar MUST be positioned LR8716D3GOWB 16 Ultima Grab over a wood stud Bar w Curl Grip 5 Moving the decorative cover as far away from the marked slots as possible drill a Old World Bronze Finish 1 14 Bar hole into the marks through the slots as shown in illustration Position the drill at a slight angle in order to get around the grab bar and decorative cover makinc LR8724DGOWB 16 Ultima Grab sure to drill into the wood stud If desired apply silicone caulk to the back of the Bar w Curl Grip decorative cover to guard against water penetration Old World Bronze Finish 1 4 Bar 6 To mount the grab bar reposition one end of the grab bar SecureMount i mounting flange over the marked holes 7 Thread a washer onto each screw Using the screwdriver screw the wood screws with washers into the SecureMount mounting flange at one end of the grab bar Materials Then screw the wood screws with washers into the mounting flange at the other end of the grab bar 8 Tighten the screws until secure 1 12 Grab Bar rods are formed from 9 Slid
Download Pdf Manuals
Related Search